- 17 Oct, 2008 40 commits
-
-
Steven Toth authored
Remove spurious messages and turn into debug. Signed-off-by:
Steven Toth <stoth@linuxtv.org> Signed-off-by:
Mauro Carvalho Chehab <mchehab@redhat.com>
-
Steven Toth authored
MFE: videobuf-dvb.c checkpatch cleanup as part of MFE merge Signed-off-by:
-
Jose Alberto Reguero authored
Jose reported: I am using a Avermedia Volar X with af9015 driver(DVB-T). The first time you use the card, first call reconfigure with MXL_QAM, and when tune DVB-T it calls reconfigure with MXL_DVBT. But if you close the frontend and open again, it calls reconfigure with MXL_QAM, but not call reconfigure with MXL_DVBT because state->current_mode don't change (is MXL_DVBT). Signed-off-by:
Jose Alberto Reguero <jareguero@telefonica.net> Signed-off-by:
-
Darron Broad authored
To optimise data storage even further one other redundant var has been removed. This also removes a redundant assignment. Signed-off-by:
Darron Broad <darron@kewl.org> Signed-off-by:
-
Christophe Thommeret authored
Christophe divulged the following: "Since 8PSK (and higher mod) signals are very likely to have pilot symbols, pilot_auto should start with pilot_on for 8PSK. And since QPSK signals are unlikely to have pilot, pilot_auto should start with pilot_off for QPSK. Without the patch: QPSK tuning delay: ~100ms 8PSK tuning delay: ~900ms with patch: QPSK tuning delay: ~100ms 8PSK tuning delay: ~100ms " This patch does as Cristophe asks. In emulated auto-pilot we choose pilot-on for tuning PSK_8 and pilot-off for tuning QPSK. Signed-off-by:
-
Darron Broad authored
This adds I2S-ADC tvaudio mode as a formal method of audio delivery. This fixes one bug and adds fm audio via I2S-ADC on cards that support it. The bug occured before when I2S-ADC mode was initiated on composite/s-video open but was then reset within 500ms by the audio thread which used any previous audio tuning details. Signed-off-by:
-
Darron Broad authored
This tuner was already supported by proxy as an FMD1216ME, however, the MEX uses a different FM Radio IF so this addition is now required. Signed-off-by:
-
Darron Broad authored
This adds audio routing for the hvr-1300/3000/4000 cards enabling FM audio for the I2S ADC method of the cx88. At this time only the HVR-4000 has been tested. It is assumed the HVR-3000/1300 are the same. Signed-off-by:
-
Darron Broad authored
This fixes attachment failure where we now unwind attachment and skip non-attached nodes where necessary so we can survive a fault situation correctly. Signed-off-by:
-
Darron Broad authored
To optimise data storage redundant vars are removed. Signed-off-by:
-
Darron Broad authored
When moving from one frontend to another an application could spawn multiple threads opening the same new frontend and in some circumstances all of these could become delayed waiting for the previous frontend readers or previous frontend writer thread to complete. In this scenario the first thread will succeed on open to bring the new frontend online but any others will return EBUSY. This is a fault. If the first succeeds and all others are on the same frontend then they should succeed also. Signed-off-by:
-
Steven Toth authored
mxl5005s: Checkpatch compliance Signed-off-by:
-
Steven Toth authored
A number of users have complained that their syslog often shows this messages but it doesn't impact performance. I'm changing this to a debug message, so developers will still see the message during testing and users will no longer be bothered by this. Signed-off-by:
-
Steven Toth authored
xc5000: Checkpatch compliance Signed-off-by:
-
Steven Toth authored
cx24123: Checkpatch compliance Signed-off-by:
-
Steven Toth authored
s5h1411: Checkpatch compliance Signed-off-by:
-
Steven Toth authored
s5h1409: Checkpatch compliance Signed-off-by:
-
Steven Toth authored
cx24116: Checkpatch compliance #3 Signed-off-by:
-
Steven Toth authored
cx22702: Checkpatch compliance Signed-off-by:
-
Steven Toth authored
tda10048: Checkpatch compliance Signed-off-by:
-
Steven Toth authored
cx24116: Checkpatch compliance #2 Signed-off-by:
-
Steven Toth authored
cx24116: Checkpatch compliance Signed-off-by:
-
Steven Toth authored
au0828: Checkpatch compliance Signed-off-by:
-
Steven Toth authored
cx23885: Checkpatch compliance Signed-off-by:
-
Steven Toth authored
cx88: Convert __FUNCTION__ to __func__ Signed-off-by:
-
Michael Krufky authored
Autodetect 2040:5520 and 2040:5530 as Hauppauge WinTV MiniStick Signed-off-by:
Michael Krufky <mkrufky@linuxtv.org> Signed-off-by:
-
Michael Krufky authored
Add autodetection support for a new revision of the Hauppauge HVR950Q (2040:721e) Signed-off-by:
-
Magnus Damm authored
Update the soc_camera_platform header with licensing information. Signed-off-by:
Magnus Damm <damm@igel.co.jp> Signed-off-by:
Guennadi Liakhovetski <g.liakhovetski@gmx.de> Signed-off-by:
-
Magnus Damm authored
This patch improves the buffer handling in the sh_mobile_ceu driver. Instead of marking all queued buffers as VIDEOBUF_ACTIVE the code now marks queued-but-not-active buffers as VIDEOBUF_QUEUED and buffers involved in dma as VIDEOBUF_ACTIVE. The code is also updated with code to cancel active buffers, thanks to Morimoto-san. Tested-by:
Kuninori Morimoto <morimoto.kuninori@renesas.com> Signed-off-by:
-
Magnus Damm authored
Extend the sh_mobile_ceu driver to enable byte swap. This way bytes are stored in memory in incoming byte order. Signed-off-by:
-
Magnus Damm authored
This patch adds CEU hardware block comments to the sh_mobile_ceu driver. Signed-off-by:
-
Guennadi Liakhovetski authored
Switching sensors on and off is now done by sensor drivers themselves, typically using platform-provided hooks. Update soc_camera_platform.c to do the same. Also remove a refundant struct soc_camera_platform_info definition from soc_camera_platform.c. Tested-by:
-
Jean Delvare authored
Signed-off-by:
Jean Delvare <khali@linux-fr.org> Signed-off-by:
-
Magnus Damm authored
This patch adds RGB555 pixel format support to the vivi driver. Both little endian and big endian versions are added. The driver follows the RGB pixel format described in Table 2-2 of the V4L2 API spec, _not_ the older BGR interpretation described in Table 2-1. Signed-off-by:
-
Magnus Damm authored
This patch adds RGB565 pixel format support to the vivi driver. Both little endian and big endian versions are added. The driver follows the RGB pixel format described in Table 2-2 of the V4L2 API spec, _not_ the older BGR interpretation described in Table 2-1. Signed-off-by:
-
Magnus Damm authored
This patch simply adds UYVY pixel format support to the vivi driver. Signed-off-by:
-
Magnus Damm authored
This patch contains the ground work to add support for multiple pixel formats to vivi.c Signed-off-by:
-
Magnus Damm authored
This patch improves the color space conversion code in vivi.c to directly draw with precalculated YUV values as palette instead of drawing with YUV that is calculated from RGB for every two pixels. This way we eliminate the need for 9 multiplications every two pixels. A side effect of this patch is that the time counter is changed from green text on black background to white text on black background. Signed-off-by:
-
Jean Delvare authored
There's no point in logging two messages for the same error. Signed-off-by:
-
Steven Toth authored
cx23885 frontend allocation code needs to exist in the higher function, and it also needs to ensure videobug is also correctly initialised on a per frontend basis. This code uses the previous num_frontends patch to safely init each future MFE frontend on a single tsport as as safely as possible - given that we don't have any of those boards. Again, better to add all of this safety code now, while the MFE patch set is fresh in everyone mind, than to try and add it 12-24 months from now, when the subject is cold. Signed-off-by:
-
