• Johan Rudholm's avatar
    mmc: core: Fixup signal voltage switch · 0797e5f1
    Johan Rudholm authored
    When switching SD and SDIO cards from 3.3V to 1.8V signal levels, the
    clock should be gated for 5 ms during the step. After enabling the
    clock, the host should wait for at least 1 ms before checking for
    failure. Failure by the card to switch is indicated by dat[0:3] being
    pulled low. The host should check for this condition and power-cycle
    the card if failure is indicated.
    
    Add a retry mechanism for the SDIO case.
    
    If the voltage switch fails repeatedly, give up and continue the
    initialization using the original voltage.
    
    This patch places a couple of requirements on the host driver:
    
     1) mmc_set_ios with ios.clock = 0 must gate the clock
     2) mmc_power_off must actually cut the power to the card
     3) The card_busy host_ops member must be implemented
    
    if these requirements are not fulfilled, the 1.8V signal voltage switch
    will still be attempted but may not be successful.
    Signed-off-by: default avatarJohan Rudholm <johan.rudholm@stericsson.com>
    Signed-off-by: default avatarKevin Liu <kliu5@marvell.com>
    Acked-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
    Tested-by: default avatarWei WANG <wei_wang@realsil.com.cn>
    Signed-off-by: default avatarChris Ball <cjb@laptop.org>
    0797e5f1
core.c 67.1 KB