• Tony Lindgren's avatar
    ARM: dts: Fix gpio interrupts for dm816x · 599c376c
    Tony Lindgren authored
    Commit 7800064b ("ARM: dts: Add basic dm816x device tree
    configuration") added basic devices for dm816x, but I was not able
    to test the GPIO interrupts earlier until I found some suitable pins
    to test with. We can mux the MMC card detect and write protect pins
    from SD_SDCD and SD_SDWP mode to use a normal GPIO interrupts that
    are also suitable for the MMC subsystem.
    
    This turned out several issues that need to be fixed:
    
    - I set the GPIO type wrong to be compatible with omap3 instead
      of omap4. The GPIO controller on dm816x has EOI interrupt
      register like omap4 and am335x.
    
    - I got the GPIO interrupt numbers wrong as each bank has two
      and we only use one. They need to be set up the same way as
      on am335x.
    
    - The gpio banks are missing interrupt controller related
      properties.
    
    With these changes the GPIO interrupts can be used with the
    MMC card detect pin, so let's wire that up. Let's also mux all
    the MMC lines for completeness while at it.
    
    For the first GPIO bank I tested using GPMC lines temporarily
    muxed to GPIOs on the dip switch 10.
    
    Cc: Brian Hutchinson <b.hutchman@gmail.com>
    Cc: Matthijs van Duin <matthijsvanduin@gmail.com>
    Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
    599c376c
dm8168-evm.dts 3.89 KB