On dGfx, the PL1 power limit being enabled and set to a low value results
in a low GPU operating freq. It also negates the freq raise operation which
is done before GuC firmware load. As a result GuC firmware load can time
out. Such timeouts were seen in the GL #8062 bug below (where the PL1 power
limit was enabled and set to a low value). Therefore disable the PL1 power
limit when allowed by HW when loading GuC firmware.

v2:
 - Take mutex (to disallow writes to power1_max) across GuC reset/fw load
 - Add hwm_power_max_restore to error return code path

v3 (Jani N):
 - Add/remove explanatory comments
 - Function renames
 - Type corrections
 - Locking annotation

v4:
 - Don't hold the lock across GuC reset (Rodrigo)
 - New locking scheme (suggested by Rodrigo)
 - Eliminate rpm_get in power_max_disable/restore, not needed (Tvrtko)

v5:
 - Fix uninitialized pl1en variable compile warning reported by kernel
   build robot by creating new err_rps label

Link: https://gitlab.freedesktop.org/drm/intel/-/issues/8062Signed-off-by: Ashutosh Dixit <ashutosh.dixit@intel.com>
Reviewed-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230420164041.1428455-3-ashutosh.dixit@intel.com