-
David Howells authored
Use direct assignment rather than cmpxchg() as the latter is unavailable and unimplementable on some platforms and is actually unnecessary. The use of cmpxchg() was to guard against two possibilities, neither of which can actually occur: (1) The pending flag may have been unset or may be cleared. However, given where it's called, the pending flag is _always_ set. I don't think it can be unset whilst we're in set_wq_data(). Once the work is enqueued to be actually run, the only way off the queue is for it to be actually run. If it's a delayed work item, then the bit can't be cleared by the timer because we haven't started the timer yet. Also, the pending bit can't be cleared by cancelling the delayed work _until_ the work item has had its timer started. (2) The workqueue pointer might change. This can only happen in two cases: (a) The work item has just been queued to actually run, and so we're protected by the appropriate workqueue spinlock. (b) A delayed work item is being queued, and so the timer hasn't been started yet, and so no one else knows about the work item or can access it (the pending bit protects us). Besides, set_wq_data() _sets_ the workqueue pointer unconditionally, so it can be assigned instead. So, replacing the set_wq_data() with a straight assignment would be okay in most cases. The problem is where we end up tangling with test_and_set_bit() emulated using spinlocks, and even then it's not a problem _provided_ test_and_set_bit() doesn't attempt to modify the word if the bit was set. If that's a problem, then a bitops-proofed assignment will be required - equivalent to atomic_set() vs other atomic_xxx() ops. Signed-off-by:
David Howells <dhowells@redhat.com> Signed-off-by:
Linus Torvalds <torvalds@osdl.org>
4594bf15