• Christophe Ricard's avatar
    NFC: st21nfca: Add support for proprietary commands · 15d17170
    Christophe Ricard authored
    Add support for proprietary commands useful mainly
    for factory testings.
    
    Here is a list:
    
    - FACTORY_MODE: Allow to set the driver into a mode where no
      secure element are activated. It does not consider any
      NFC_ATTR_VENDOR_DATA.
    - HCI_CLEAR_ALL_PIPES: Allow to execute a HCI clear all pipes
      command. It does not consider any NFC_ATTR_VENDOR_DATA.
    - HCI_DM_PUT_DATA: Allow to configure specific CLF registry as
      for example RF trimmings or low level drivers configurations
      (I2C, SPI, SWP).
    - HCI_DM_UPDATE_AID: Allow to configure an AID routing into the
      CLF routing table following RF technology, CLF mode or protocol.
    - HCI_DM_GET_INFO: Allow to retrieve CLF information.
    - HCI_DM_GET_DATA: Allow to retrieve CLF configurable data such as
      low level drivers configurations or RF trimmings.
    - HCI_DM_LOAD: Allow to load a firmware into the CLF. A complete
      packet can be more than 8KB.
    - HCI_DM_RESET: Allow to run a CLF reset in order to "commit" CLF
      configuration changes without CLF power off.
    - HCI_GET_PARAM: Allow to retrieve an HCI CLF parameter (for example
      the white list).
    - HCI_DM_FIELD_GENERATOR: Allow to generate different kind of RF
      technology. When using this command to anti-collision is done.
    - HCI_LOOPBACK: Allow to echo a command and test the Dh to CLF
      connectivity.
    Signed-off-by: default avatarChristophe Ricard <christophe-h.ricard@st.com>
    Signed-off-by: default avatarSamuel Ortiz <sameo@linux.intel.com>
    15d17170
Makefile 228 Bytes