• Greg Ungerer's avatar
    m68k: move hardware vector setting from traps.c to its own file · bc4f4ac2
    Greg Ungerer authored
    Most of the trap.c code is general to all m68k arch members. But the code
    it currently contains to set the hardware vector table is quite specific to
    the 680x0 family. They can have the vector table at any address unlike
    other family members (which either support only a single fixed address,
    or a limited range of addresses). So lets move that code out to a new file,
    vectors.c. This will make sharing the rest of the trap.c code easier and
    cleaner.
    Signed-off-by: default avatarGreg Ungerer <gerg@uclinux.org>
    bc4f4ac2
Makefile 453 Bytes