This patch prepares the driver to use more than one RX-FIFO. Having a
bigger RX buffer is beneficial in high load situations, where the
system temporarily cannot keep up reading CAN frames from the chip.
Using a bigger RX buffer also allows to implement RX IRQ coalescing,
which will be added in a later patch series.

If using more than 1 RX-FIFO the driver has to figure out, which FIFOs
have RX'ed CAN frames pending. This is indicated by a set bit in the
RXIF register, which is positioned directly after the interrupt status
register INT. If more than 1 RX-FIFO is used, the driver reads both
registers in 1 transfer.

The mcp251xfd_handle_rxif() function iterates over all RX rings and
reads out the RX'ed CAN frames for for all pending FIFOs. To keep the
logic for the 1 RX-FIFO only case in mcp251xfd_handle_rxif() simple,
the driver marks that FIFO pending in mcp251xfd_ring_init().

The chip has a dedicated RX interrupt line to signal pending RX'ed
frames. If connected to an input GPIO and the driver will skip the
initial read of the interrupt status register (INT) and directly read
the pending RX'ed frames if the line is active. The driver assumes the
1st RX-FIFO pending (a read of the RXIF register would re-introduce
the skipped initial read of the INT register). Any other pending
RX-FIFO will be served in the main interrupt handler.

Link: https://lore.kernel.org/all/20220217103826.2299157-8-mkl@pengutronix.deSigned-off-by: Marc Kleine-Budde <mkl@pengutronix.de>