-
Giuseppe CAVALLARO authored
This patch adds the support for the Energy-Efficient Ethernet (EEE) to the Physical Abstraction Layer. To support the EEE we have to access to the MMD registers 3.20 and 7.60/61. So two new functions have been added to read/write the MMD registers (clause 45). An Ethernet driver (I tested the stmmac) can invoke the phy_init_eee to properly check if the EEE is supported by the PHYs and it can also set the clock stop enable bit in the 3.0 register. The phy_get_eee_err can be used for reporting the number of time where the PHY failed to complete its normal wake sequence. In the end, this patch also adds the EEE ethtool support implementing: o phy_ethtool_set_eee o phy_ethtool_get_eee v1: initial patch v2: fixed some errors especially on naming convention v3: renamed again the mmd read/write functions thank to Ben's feedback v4: moved file to phy.c and added the ethtool support. v5: fixed phy_adv_to_eee, phy_eee_to_supported, phy_eee_to_adv return values according to ethtool API (thanks to Ben's feedback). Renamed some macros to avoid too long names. v6: fixed kernel-doc comments to be properly parsed. Fixed the phy_init_eee function: we need to check which link mode was autonegotiated and then the corresponding bits in 7.60 and 7.61 registers. v7: reviewed the way to get the negotiated settings. v8: fixed a problem in the phy_init_eee return value erroneously added when included the phy_read_status call. v9: do not remove the MDIO_AN_EEE_ADV_100TX and MDIO_AN_EEE_ADV_1000T and fixed the eee_{cap,lp,adv} declaration as "int" instead of u16. Signed-off-by:
Giuseppe Cavallaro <peppe.cavallaro@st.com> Reviewed-by:
Ben Hutchings <bhutchings@solarflare.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
a59a4d19