net: macb: Add support for sgmii phy interface

This patch adds support for the sgmii phy interface.
Signed-off-by: Punnaiah Choudary Kalluri <punnaia@xilinx.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/cadence/macb.c

@@ -1682,6 +1682,8 @@ static void macb_init_hw(struct macb *bp)
 	macb_set_hwaddr(bp);
 
 	config = macb_mdc_clk_div(bp);
+	if (bp->phy_interface == PHY_INTERFACE_MODE_SGMII)
+		config |= GEM_BIT(SGMIIEN) | GEM_BIT(PCSSEL);
 	config |= MACB_BF(RBOF, NET_IP_ALIGN);	/* Make eth data aligned */
 	config |= MACB_BIT(PAE);		/* PAuse Enable */
 	config |= MACB_BIT(DRFCS);		/* Discard Rx FCS */
@@ -2416,6 +2418,8 @@ static int macb_init(struct platform_device *pdev)
 	/* Set MII management clock divider */
 	val = macb_mdc_clk_div(bp);
 	val |= macb_dbw(bp);
+	if (bp->phy_interface == PHY_INTERFACE_MODE_SGMII)
+		val |= GEM_BIT(SGMIIEN) | GEM_BIT(PCSSEL);
 	macb_writel(bp, NCFGR, val);
 
 	return 0;

drivers/net/ethernet/cadence/macb.h

@@ -215,12 +215,17 @@
 /* GEM specific NCFGR bitfields. */
 #define GEM_GBE_OFFSET		10 /* Gigabit mode enable */
 #define GEM_GBE_SIZE		1
+#define GEM_PCSSEL_OFFSET	11
+#define GEM_PCSSEL_SIZE		1
 #define GEM_CLK_OFFSET		18 /* MDC clock division */
 #define GEM_CLK_SIZE		3
 #define GEM_DBW_OFFSET		21 /* Data bus width */
 #define GEM_DBW_SIZE		2
 #define GEM_RXCOEN_OFFSET	24
 #define GEM_RXCOEN_SIZE		1
+#define GEM_SGMIIEN_OFFSET	27
+#define GEM_SGMIIEN_SIZE	1
+
 
 /* Constants for data bus width. */
 #define GEM_DBW32		0 /* 32 bit AMBA AHB data bus width */