Commit 0316c7e6 authored by Francesco Dolcini's avatar Francesco Dolcini Committed by David S. Miller

net: phy: micrel: ksz9131 led errata workaround

Micrel KSZ9131 PHY LED behavior is not correct when configured in
Individual Mode, LED1 (Activity LED) is in the ON state when there is
no-link.

Workaround this by setting bit 9 of register 0x1e after verifying that
the LED configuration is Individual Mode.

This issue is described in KSZ9131RNX Silicon Errata DS80000693B [*]
and according to that it will not be corrected in a future silicon
revision.

[*] https://ww1.microchip.com/downloads/en/DeviceDoc/KSZ9131RNX-Silicon-Errata-and-Data-Sheet-Clarification-80000863B.pdfSigned-off-by: default avatarFrancesco Dolcini <francesco.dolcini@toradex.com>
Reviewed-by: default avatarPhilippe Schenker <philippe.schenker@toradex.com>
Reviewed-by: default avatarAndrew Lunn <andrew@lunn.ch>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 9653e613
......@@ -1003,6 +1003,26 @@ static int ksz9131_config_rgmii_delay(struct phy_device *phydev)
txcdll_val);
}
/* Silicon Errata DS80000693B
*
* When LEDs are configured in Individual Mode, LED1 is ON in a no-link
* condition. Workaround is to set register 0x1e, bit 9, this way LED1 behaves
* according to the datasheet (off if there is no link).
*/
static int ksz9131_led_errata(struct phy_device *phydev)
{
int reg;
reg = phy_read_mmd(phydev, 2, 0);
if (reg < 0)
return reg;
if (!(reg & BIT(4)))
return 0;
return phy_set_bits(phydev, 0x1e, BIT(9));
}
static int ksz9131_config_init(struct phy_device *phydev)
{
struct device_node *of_node;
......@@ -1058,6 +1078,10 @@ static int ksz9131_config_init(struct phy_device *phydev)
if (ret < 0)
return ret;
ret = ksz9131_led_errata(phydev);
if (ret < 0)
return ret;
return 0;
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment