tg3: Use pci_dev pm_cap

Use the already existing pm_cap variable in struct pci_dev for
determining the power management offset.  This saves the driver from
having to keep track of an extra variable.
Signed-off-by: Jon Mason <jdmason@kudzu.us>
Cc: Nithin Nayak Sujir <nsujir@broadcom.com>
Cc: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/tg3.c

@@ -16193,12 +16193,12 @@ static int tg3_get_invariants(struct tg3 *tp, const struct pci_device_id *ent)
 			 * So explicitly force the chip into D0 here.
 			 */
 			pci_read_config_dword(tp->pdev,
-					      tp->pm_cap + PCI_PM_CTRL,
+					      tp->pdev->pm_cap + PCI_PM_CTRL,
 					      &pm_reg);
 			pm_reg &= ~PCI_PM_CTRL_STATE_MASK;
 			pm_reg |= PCI_PM_CTRL_PME_ENABLE | 0 /* D0 */;
 			pci_write_config_dword(tp->pdev,
-					       tp->pm_cap + PCI_PM_CTRL,
+					       tp->pdev->pm_cap + PCI_PM_CTRL,
 					       pm_reg);
 
 			/* Also, force SERR#/PERR# in PCI command. */
@@ -17347,7 +17347,6 @@ static int tg3_init_one(struct pci_dev *pdev,
 	tp = netdev_priv(dev);
 	tp->pdev = pdev;
 	tp->dev = dev;
-	tp->pm_cap = pdev->pm_cap;
 	tp->rx_mode = TG3_DEF_RX_MODE;
 	tp->tx_mode = TG3_DEF_TX_MODE;
 	tp->irq_sync = 1;

drivers/net/ethernet/broadcom/tg3.h

@@ -3234,7 +3234,6 @@ struct tg3 {
 	u8				pci_lat_timer;
 
 	int				pci_fn;
-	int				pm_cap;
 	int				msi_cap;
 	int				pcix_cap;
 	int				pcie_readrq;