Commit 03217ebb authored by Nikita Yushchenko's avatar Nikita Yushchenko Committed by Greg Kroah-Hartman

net: dsa: mv88e6xxx: avoid error message on remove from VLAN 0

[ Upstream commit 62394708 ]

When non-bridged, non-vlan'ed mv88e6xxx port is moving down, error
message is logged:

failed to kill vid 0081/0 for device eth_cu_1000_4

This is caused by call from __vlan_vid_del() with vin set to zero, over
call chain this results into _mv88e6xxx_port_vlan_del() called with
vid=0, and mv88e6xxx_vtu_get() called from there returns -EINVAL.

On symmetric path moving port up, call goes through
mv88e6xxx_port_vlan_prepare() that calls mv88e6xxx_port_check_hw_vlan()
that returns -EOPNOTSUPP for zero vid.

This patch changes mv88e6xxx_vtu_get() to also return -EOPNOTSUPP for
zero vid, then this error code is explicitly cleared in
dsa_slave_vlan_rx_kill_vid() and error message is no longer logged.
Signed-off-by: default avatarNikita Yushchenko <nikita.yoush@cogentembedded.com>
Reviewed-by: default avatarVivien Didelot <vivien.didelot@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
Signed-off-by: default avatarSasha Levin <sashal@kernel.org>
parent 3eaf80d7
......@@ -1517,7 +1517,7 @@ static int mv88e6xxx_vtu_get(struct mv88e6xxx_chip *chip, u16 vid,
int err;
if (!vid)
return -EINVAL;
return -EOPNOTSUPP;
entry->vid = vid - 1;
entry->valid = false;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment