sh-sci / PM: Avoid deadlocking runtime PM

The runtime PM of sh-sci devices is enabled when sci_probe() returns,
so the pm_runtime_put_sync() executed by driver_probe_device()
attempts to suspend the device.  Then, in some situations, a
diagnostic message is printed to the console by one of the runtime
suspend routines handling the sh-sci device, which causes synchronous
runtime resume to be started from the device's own runtime suspend
callback.  This causes rpm_resume() to be run eventually, which sees
the RPM_SUSPENDING status set by rpm_suspend() and waits for it to
change.  However, the device's runtime PM status cannot change at
that point, because the routine that has set it waits for the
rpm_suspend() to return.  A deadlock occurs as a result.

To avoid that make sci_init_single() increment the device's
runtime PM usage counter, so that it cannot be suspended by
driver_probe_device().  That counter has to be decremented
eventually, so make sci_startup() do that before starting to
actually use the device and make sci_shutdown() increment it
again before returning to balance the incrementation carried out by
sci_startup().
Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
Tested-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

drivers/tty/serial/sh-sci.c

@@ -1710,6 +1710,8 @@ static int sci_startup(struct uart_port *port)
 
 	dev_dbg(port->dev, "%s(%d)\n", __func__, port->line);
 
+	pm_runtime_put_noidle(port->dev);
+
 	sci_port_enable(s);
 
 	ret = sci_request_irq(s);
@@ -1737,6 +1739,8 @@ static void sci_shutdown(struct uart_port *port)
 	sci_free_irq(s);
 
 	sci_port_disable(s);
+
+	pm_runtime_get_noresume(port->dev);
 }
 
 static unsigned int sci_scbrr_calc(unsigned int algo_id, unsigned int bps,
@@ -2075,6 +2079,7 @@ static int __devinit sci_init_single(struct platform_device *dev,
 		sci_init_gpios(sci_port);
 
 		pm_runtime_irq_safe(&dev->dev);
+		pm_runtime_get_noresume(&dev->dev);
 		pm_runtime_enable(&dev->dev);
 	}