net: hns3: add some error checking in hclge_tm module

When hdev->tx_sch_mode is HCLGE_FLAG_VNET_BASE_SCH_MODE, the
hclge_tm_schd_mode_vnet_base_cfg calls hclge_tm_pri_schd_mode_cfg
with vport->vport_id as pri_id, which is used as index for
hdev->tm_info.tc_info, it will cause out of bound access issue
if vport_id is equal to or larger than HNAE3_MAX_TC.

Also hardware only support maximum speed of HCLGE_ETHER_MAX_RATE.

So this patch adds two checks for above cases.

Fixes: 84844054 ("net: hns3: Add support of TX Scheduler & Shaper to HNS3 driver")
Signed-off-by: Yunsheng Lin <linyunsheng@huawei.com>
Signed-off-by: Peng Li <lipeng321@huawei.com>
Signed-off-by: Huazhong Tan <tanhuazhong@huawei.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.c

@@ -58,7 +58,8 @@ static int hclge_shaper_para_calc(u32 ir, u8 shaper_level,
 	u32 tick;
 
 	/* Calc tick */
-	if (shaper_level >= HCLGE_SHAPER_LVL_CNT)
+	if (shaper_level >= HCLGE_SHAPER_LVL_CNT ||
+	    ir > HCLGE_ETHER_MAX_RATE)
 		return -EINVAL;
 
 	tick = tick_array[shaper_level];
@@ -1138,6 +1139,9 @@ static int hclge_tm_schd_mode_vnet_base_cfg(struct hclge_vport *vport)
 	int ret;
 	u8 i;
 
+	if (vport->vport_id >= HNAE3_MAX_TC)
+		return -EINVAL;
+
 	ret = hclge_tm_pri_schd_mode_cfg(hdev, vport->vport_id);
 	if (ret)
 		return ret;