Commit 054531e7 authored by Sergei Shtylyov's avatar Sergei Shtylyov Committed by Simon Horman

ARM: shmobile: silk: add eMMC DT support

Define the SILK board dependent part of the MMCIF device node (the board has
eMMC chip) along with the  necessary voltage regulator (note that the Vcc/Vccq
regulator is dummy -- it's required by the MMCIF driver but doesn't actually
exist on the board).

Based on the original patch by Vladimir Barinov
<vladimir.barinov@cogentembedded.com>.
Signed-off-by: default avatarSergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: default avatarSimon Horman <horms+renesas@verge.net.au>
parent 6cdf6ba1
......@@ -30,6 +30,15 @@ memory@40000000 {
device_type = "memory";
reg = <0 0x40000000 0 0x40000000>;
};
d3_3v: regulator@0 {
compatible = "regulator-fixed";
regulator-name = "D3.3V";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
regulator-boot-on;
regulator-always-on;
};
};
&extal_clk {
......@@ -51,6 +60,11 @@ phy1_pins: phy1 {
renesas,groups = "intc_irq8";
renesas,function = "intc";
};
mmcif0_pins: mmcif0 {
renesas,groups = "mmc_data8", "mmc_ctrl";
renesas,function = "mmc";
};
};
&scif2 {
......@@ -75,3 +89,14 @@ phy1: ethernet-phy@1 {
micrel,led-mode = <1>;
};
};
&mmcif0 {
pinctrl-0 = <&mmcif0_pins>;
pinctrl-names = "default";
vmmc-supply = <&d3_3v>;
vqmmc-supply = <&d3_3v>;
bus-width = <8>;
non-removable;
status = "okay";
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment