bnx2x: Fix to prevent inner-reload

Submit 909d9faa ("bnx2x: Prevent inner-reload while VFs exist")
contained a bug - MTU change was not prevented by it; Instead, it
`randomally' prevented bnx2x_resume() from running [harmless yet wrong].

This moves the check to its correct spot.
Signed-off-by: Yuval Mintz <Yuval.Mintz@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c

@@ -4786,6 +4786,11 @@ int bnx2x_change_mtu(struct net_device *dev, int new_mtu)
 {
 	struct bnx2x *bp = netdev_priv(dev);
 
+	if (pci_num_vf(bp->pdev)) {
+		DP(BNX2X_MSG_IOV, "VFs are enabled, can not change MTU\n");
+		return -EPERM;
+	}
+
 	if (bp->recovery_state != BNX2X_RECOVERY_DONE) {
 		BNX2X_ERR("Can't perform change MTU during parity recovery\n");
 		return -EAGAIN;
@@ -4938,11 +4943,6 @@ int bnx2x_resume(struct pci_dev *pdev)
 	}
 	bp = netdev_priv(dev);
 
-	if (pci_num_vf(bp->pdev)) {
-		DP(BNX2X_MSG_IOV, "VFs are enabled, can not change MTU\n");
-		return -EPERM;
-	}
-
 	if (bp->recovery_state != BNX2X_RECOVERY_DONE) {
 		BNX2X_ERR("Handling parity error recovery. Try again later\n");
 		return -EAGAIN;