Commit 0a8da30d authored by Stefan Richter's avatar Stefan Richter

firewire: update Kconfig help text

Remove some less necessary information, point out that video1394 and
dv1394 should be blacklisted along with ohci1394.
Signed-off-by: default avatarStefan Richter <stefanr@s5r6.in-berlin.de>
parent a2cdebe3
# -*- shell-script -*-
comment "An alternative FireWire stack is available with EXPERIMENTAL=y"
depends on EXPERIMENTAL=n
......@@ -21,27 +19,7 @@ config FIREWIRE
NOTE:
You should only build ONE of the stacks, unless you REALLY know what
you are doing. If you install both, you should configure them only as
modules rather than link them statically, and you should blacklist one
of the concurrent low-level drivers in /etc/modprobe.conf. Add either
blacklist firewire-ohci
or
blacklist ohci1394
there depending on which driver you DON'T want to have auto-loaded.
You can optionally do the same with the other IEEE 1394/ FireWire
drivers.
If you have an old modprobe which doesn't implement the blacklist
directive, use either
install firewire-ohci /bin/true
or
install ohci1394 /bin/true
and so on, depending on which modules you DON't want to have
auto-loaded.
you are doing.
config FIREWIRE_OHCI
tristate "Support for OHCI FireWire host controllers"
......@@ -57,8 +35,24 @@ config FIREWIRE_OHCI
NOTE:
If you also build ohci1394 of the classic stack, blacklist either
ohci1394 or firewire-ohci to let hotplug load only the desired driver.
You should only build ohci1394 or firewire-ohci, but not both.
If you nevertheless want to install both, you should configure them
only as modules and blacklist the driver(s) which you don't want to
have auto-loaded. Add either
blacklist firewire-ohci
or
blacklist ohci1394
blacklist video1394
blacklist dv1394
to /etc/modprobe.conf or /etc/modprobe.d/* and update modprobe.conf
depending on your distribution. The latter two modules should be
blacklisted together with ohci1394 because they depend on ohci1394.
If you have an old modprobe which doesn't implement the blacklist
directive, use "install modulename /bin/true" for the modules to be
blacklisted.
config FIREWIRE_SBP2
tristate "Support for storage devices (SBP-2 protocol driver)"
......@@ -75,9 +69,3 @@ config FIREWIRE_SBP2
You should also enable support for disks, CD-ROMs, etc. in the SCSI
configuration section.
NOTE:
If you also build sbp2 of the classic stack, blacklist either sbp2
or firewire-sbp2 to let hotplug load only the desired driver.
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment