atl1c: dont use highprio tx queue

This driver attempts to use two TX rings but lacks proper support :

1) IRQ handler only takes care of TX completion on first TX ring
2) the stop/start logic uses the legacy functions (for non multiqueue
drivers)

This means all packets witk skb mark set to 1 are sent through high
queue but are never cleaned and queue eventualy fills and block the
device, triggering the infamous "NETDEV WATCHDOG" message.

Lets use a single TX ring to fix the problem, this driver is not a real
multiqueue one yet.

Minimal fix for stable kernels.
Reported-by: Thomas Meyer <thomas@m3y3r.de>
Tested-by: Thomas Meyer <thomas@m3y3r.de>
Signed-off-by: Eric Dumazet <eric.dumazet@gmail.com>
Cc: Jay Cliburn <jcliburn@gmail.com>
Cc: Chris Snook <chris.snook@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/atheros/atl1c/atl1c_main.c

@@ -2244,10 +2244,6 @@ static netdev_tx_t atl1c_xmit_frame(struct sk_buff *skb,
 			dev_info(&adapter->pdev->dev, "tx locked\n");
 		return NETDEV_TX_LOCKED;
 	}
-	if (skb->mark == 0x01)
-		type = atl1c_trans_high;
-	else
-		type = atl1c_trans_normal;
 
 	if (atl1c_tpd_avail(adapter, type) < tpd_req) {
 		/* no enough descriptor, just stop queue */