ionic: catch transition back to RUNNING with fw_generation 0

In some graceful updates that get initially triggered by the
RESET event, especially with older firmware, the fw_generation
bits don't change but the fw_status is seen to go to 0 then back
to 1.  However, the driver didn't perform the restart, remained
waiting for fw_generation to change, and got left in limbo.

This is because the clearing of idev->fw_status_ready to 0
didn't happen correctly as it was buried in the transition
trigger: since the transition down was triggered not here
but in the RESET event handler, the clear to 0 didn't happen,
so the transition back to 1 wasn't detected.

Fix this particular case by bringing the setting of
idev->fw_status_ready back out to where it was before.

Fixes: 398d1e37 ("ionic: add FW_STOPPING state")
Signed-off-by: Shannon Nelson <snelson@pensando.io>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

drivers/net/ethernet/pensando/ionic/ionic_dev.c

@@ -206,6 +206,8 @@ int ionic_heartbeat_check(struct ionic *ionic)
 	if (fw_status_ready != idev->fw_status_ready) {
 		bool trigger = false;
 
+		idev->fw_status_ready = fw_status_ready;
+
 		if (!fw_status_ready && lif &&
 		    !test_bit(IONIC_LIF_F_FW_RESET, lif->state) &&
 		    !test_and_set_bit(IONIC_LIF_F_FW_STOPPING, lif->state)) {
@@ -222,8 +224,6 @@ int ionic_heartbeat_check(struct ionic *ionic)
 		if (trigger) {
 			struct ionic_deferred_work *work;
 
-			idev->fw_status_ready = fw_status_ready;
-
 			work = kzalloc(sizeof(*work), GFP_ATOMIC);
 			if (work) {
 				work->type = IONIC_DW_TYPE_LIF_RESET;