Commit 12d4f964 authored by Mark Einon's avatar Mark Einon Committed by Greg Kroah-Hartman

staging: et131x: rename adapter->Flags to adapter->flags

Trivial rename of the adapter flags struct member to remove camel case.
Tested on a ET-131x device.
Signed-off-by: default avatarMark Einon <mark.einon@gmail.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@suse.de>
parent 02cc343b
......@@ -229,7 +229,7 @@ void ConfigMACRegs2(struct et131x_adapter *etdev)
writel(ctl, &etdev->regs->txmac.ctl);
/* Ready to start the RXDMA/TXDMA engine */
if (etdev->Flags & fMP_ADAPTER_LOWER_POWER) {
if (etdev->flags & fMP_ADAPTER_LOWER_POWER) {
et131x_rx_dma_enable(etdev);
et131x_tx_dma_enable(etdev);
}
......
......@@ -121,7 +121,7 @@ void EnablePhyComa(struct et131x_adapter *etdev)
/* Stop sending packets. */
spin_lock_irqsave(&etdev->send_hw_lock, flags);
etdev->Flags |= fMP_ADAPTER_LOWER_POWER;
etdev->flags |= fMP_ADAPTER_LOWER_POWER;
spin_unlock_irqrestore(&etdev->send_hw_lock, flags);
/* Wait for outstanding Receive packets */
......@@ -172,7 +172,7 @@ void DisablePhyComa(struct et131x_adapter *etdev)
et131x_adapter_setup(etdev);
/* Allow Tx to restart */
etdev->Flags &= ~fMP_ADAPTER_LOWER_POWER;
etdev->flags &= ~fMP_ADAPTER_LOWER_POWER;
/* Need to re-enable Rx. */
et131x_rx_dma_enable(etdev);
......
......@@ -394,7 +394,7 @@ int et131x_rx_dma_memory_alloc(struct et131x_adapter *adapter)
SLAB_HWCACHE_ALIGN,
NULL);
adapter->Flags |= fMP_ADAPTER_RECV_LOOKASIDE;
adapter->flags |= fMP_ADAPTER_RECV_LOOKASIDE;
/* The RFDs are going to be put on lists later on, so initialize the
* lists now.
......@@ -528,9 +528,9 @@ void et131x_rx_dma_memory_free(struct et131x_adapter *adapter)
/* Free receive packet pool */
/* Destroy the lookaside (RFD) pool */
if (adapter->Flags & fMP_ADAPTER_RECV_LOOKASIDE) {
if (adapter->flags & fMP_ADAPTER_RECV_LOOKASIDE) {
kmem_cache_destroy(rx_ring->RecvLookaside);
adapter->Flags &= ~fMP_ADAPTER_RECV_LOOKASIDE;
adapter->flags &= ~fMP_ADAPTER_RECV_LOOKASIDE;
}
/* Free the FBR Lookup Table */
......
......@@ -307,7 +307,7 @@ int et131x_send_packets(struct sk_buff *skb, struct net_device *netdev)
/* We need to see if the link is up; if it's not, make the
* netif layer think we're good and drop the packet
*/
if ((etdev->Flags & fMP_ADAPTER_FAIL_SEND_MASK) ||
if ((etdev->flags & fMP_ADAPTER_FAIL_SEND_MASK) ||
!netif_carrier_ok(netdev)) {
dev_kfree_skb_any(skb);
skb = NULL;
......
......@@ -150,7 +150,7 @@ struct et131x_adapter {
struct work_struct task;
/* Flags that indicate current state of the adapter */
u32 Flags;
u32 flags;
u32 HwErrCount;
/* Configuration */
......
......@@ -162,7 +162,7 @@ int et131x_open(struct net_device *netdev)
/* Enable device interrupts */
et131x_enable_interrupts(adapter);
adapter->Flags |= fMP_ADAPTER_INTERRUPT_IN_USE;
adapter->flags |= fMP_ADAPTER_INTERRUPT_IN_USE;
/* We're ready to move some data, so start the queue */
netif_start_queue(netdev);
......@@ -190,7 +190,7 @@ int et131x_close(struct net_device *netdev)
et131x_disable_interrupts(adapter);
/* Deregistering ISR */
adapter->Flags &= ~fMP_ADAPTER_INTERRUPT_IN_USE;
adapter->flags &= ~fMP_ADAPTER_INTERRUPT_IN_USE;
free_irq(netdev->irq, netdev);
/* Stop the error timer */
......@@ -449,11 +449,11 @@ void et131x_tx_timeout(struct net_device *netdev)
/* Any nonrecoverable hardware error?
* Checks adapter->flags for any failure in phy reading
*/
if (etdev->Flags & fMP_ADAPTER_NON_RECOVER_ERROR)
if (etdev->flags & fMP_ADAPTER_NON_RECOVER_ERROR)
return;
/* Hardware failure? */
if (etdev->Flags & fMP_ADAPTER_HARDWARE_ERROR) {
if (etdev->flags & fMP_ADAPTER_HARDWARE_ERROR) {
dev_err(&etdev->pdev->dev, "hardware error - reset\n");
return;
}
......@@ -471,7 +471,7 @@ void et131x_tx_timeout(struct net_device *netdev)
flags);
dev_warn(&etdev->pdev->dev,
"Send stuck - reset. tcb->WrIndex %x, Flags 0x%08x\n",
"Send stuck - reset. tcb->WrIndex %x, flags 0x%08x\n",
tcb->index,
tcb->flags);
......@@ -540,7 +540,7 @@ int et131x_change_mtu(struct net_device *netdev, int new_mtu)
et131x_adapter_setup(adapter);
/* Enable interrupts */
if (adapter->Flags & fMP_ADAPTER_INTERRUPT_IN_USE)
if (adapter->flags & fMP_ADAPTER_INTERRUPT_IN_USE)
et131x_enable_interrupts(adapter);
/* Restart the Tx and Rx DMA engines */
......@@ -622,7 +622,7 @@ int et131x_set_mac_addr(struct net_device *netdev, void *new_mac)
et131x_adapter_setup(adapter);
/* Enable interrupts */
if (adapter->Flags & fMP_ADAPTER_INTERRUPT_IN_USE)
if (adapter->flags & fMP_ADAPTER_INTERRUPT_IN_USE)
et131x_enable_interrupts(adapter);
/* Restart the Tx and Rx DMA engines */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment