GFS2: Update i_size properly on fallocate

This addresses an issue caught by fsx where the inode size was not being
updated to the expected value after fallocate(2) with mode 0.

The problem was caused by the offset and len parameters being converted
to multiples of the file system's block size, so i_size would be rounded
up to the nearest block size multiple instead of the requested size.

This replaces the per-chunk i_size updates with a single i_size_write on
successful completion of the operation.  With this patch gfs2 gets
through a complete run of fsx.

For clarity, the check for (error == 0) following the loop is removed as
all failures before that point jump to out_* labels or return.
Signed-off-by: Andrew Price <anprice@redhat.com>
Signed-off-by: Steven Whitehouse <swhiteho@redhat.com>

fs/gfs2/file.c

@@ -729,7 +729,6 @@ static int fallocate_chunk(struct inode *inode, loff_t offset, loff_t len,
 	struct gfs2_inode *ip = GFS2_I(inode);
 	struct buffer_head *dibh;
 	int error;
-	loff_t size = len;
 	unsigned int nr_blks;
 	sector_t lblock = offset >> inode->i_blkbits;
 
@@ -763,11 +762,6 @@ static int fallocate_chunk(struct inode *inode, loff_t offset, loff_t len,
 			goto out;
 		}
 	}
-	if (offset + size > inode->i_size && !(mode & FALLOC_FL_KEEP_SIZE))
-		i_size_write(inode, offset + size);
-
-	mark_inode_dirty(inode);
-
 out:
 	brelse(dibh);
 	return error;
@@ -878,9 +872,12 @@ static long __gfs2_fallocate(struct file *file, int mode, loff_t offset, loff_t
 		gfs2_quota_unlock(ip);
 	}
 
-	if (error == 0)
-		error = generic_write_sync(file, pos, count);
-	return error;
+	if (!(mode & FALLOC_FL_KEEP_SIZE) && (pos + count) > inode->i_size) {
+		i_size_write(inode, pos + count);
+		mark_inode_dirty(inode);
+	}
+
+	return generic_write_sync(file, pos, count);
 
 out_trans_fail:
 	gfs2_inplace_release(ip);