Commit 1a8adb67 authored by Arik Nemtsov's avatar Arik Nemtsov Committed by Luciano Coelho

wl12xx: AP-mode - configure HT rate support to the FW

Unconditionally configure HT rate support to the FW on all ACs
when starting the AP.

When 11n support is disabled by usermode (hostapd), each STA joining
the AP will appear as a non-HT STA. This will stop us from accidentally
transmitting using MCS rates.
Signed-off-by: default avatarArik Nemtsov <arik@wizery.com>
Signed-off-by: default avatarEliad Peller <eliad@wizery.com>
Signed-off-by: default avatarLuciano Coelho <coelho@ti.com>
parent 99d5ad7b
......@@ -441,6 +441,11 @@ struct conf_rx_settings {
CONF_HW_BIT_RATE_36MBPS | CONF_HW_BIT_RATE_48MBPS | \
CONF_HW_BIT_RATE_54MBPS)
#define CONF_TX_MCS_RATES (CONF_HW_BIT_RATE_MCS_0 | \
CONF_HW_BIT_RATE_MCS_1 | CONF_HW_BIT_RATE_MCS_2 | \
CONF_HW_BIT_RATE_MCS_3 | CONF_HW_BIT_RATE_MCS_4 | \
CONF_HW_BIT_RATE_MCS_5 | CONF_HW_BIT_RATE_MCS_6 | \
CONF_HW_BIT_RATE_MCS_7)
/*
* Default rates for management traffic when operating in AP mode. This
......
......@@ -515,6 +515,9 @@ int wl1271_init_ap_rates(struct wl1271 *wl)
else
supported_rates = CONF_TX_AP_ENABLED_RATES;
/* unconditionally enable HT rates */
supported_rates |= CONF_TX_MCS_RATES;
/* configure unicast TX rate classes */
for (i = 0; i < wl->conf.tx.ac_conf_count; i++) {
rc.enabled_rates = supported_rates;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment