ARM: dts: add PM8058 LEDs to the APQ8060 Dragonboard

This adds the PM8058 LEDs as used in the platform.

Cc: linux-arm-msm@vger.kernel.org
Cc: linux-leds@vger.kernel.org
Cc: Andy Gross <andy.gross@linaro.org>
Cc: Stephen Boyd <sboyd@codeaurora.org>
Cc: Jacek Anaszewski <j.anaszewski@samsung.com>
Reviewed-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Jacek Anaszewski <j.anaszewski@samsung.com>
Signed-off-by: Andy Gross <andy.gross@linaro.org>

arch/arm/boot/dts/qcom-apq8060-dragonboard.dts

@@ -239,6 +239,45 @@ pinconf {
 						};
 					};
 				};
+
+				led@48 {
+					/*
+					 * The keypad LED @0x48 is routed to
+					 * the sensor board where it is
+					 * connected to an infrared LED
+					 * SFH4650 (60mW, @850nm) next to the
+					 * ambient light and proximity sensor
+					 * Capella Microsystems CM3605.
+					 */
+					compatible = "qcom,pm8058-keypad-led";
+					reg = <0x48>;
+					label = "pm8058:infrared:proximitysensor";
+					default-state = "off";
+				};
+				led@131 {
+					compatible = "qcom,pm8058-led";
+					reg = <0x131>;
+					label = "pm8058:red";
+					default-state = "off";
+				};
+				led@132 {
+					/*
+					 * This is actually green too on my
+					 * board, but documented as yellow.
+					 */
+					compatible = "qcom,pm8058-led";
+					reg = <0x132>;
+					label = "pm8058:yellow";
+					default-state = "off";
+					linux,default-trigger = "mmc0";
+				};
+				led@133 {
+					compatible = "qcom,pm8058-led";
+					reg = <0x133>;
+					label = "pm8058:green";
+					default-state = "on";
+					linux,default-trigger = "heartbeat";
+				};
 			};
 		};