Commit 24877687 authored by Song, Yoong Siang's avatar Song, Yoong Siang Committed by Jakub Kicinski

net: stmmac: fix CBS idleslope and sendslope calculation

When link speed is not 100 Mbps, port transmit rate and speed divider
are set to 8 and 1000000 respectively. These values are incorrect for
CBS idleslope and sendslope HW values calculation if the link speed is
not 1 Gbps.

This patch adds switch statement to set the values of port transmit rate
and speed divider for 10 Gbps, 5 Gbps, 2.5 Gbps, 1 Gbps, and 100 Mbps.
Note that CBS is not supported at 10 Mbps.

Fixes: bc41a668 ("net: stmmac: tc: Remove the speed dependency")
Fixes: 1f705bc6 ("net: stmmac: Add support for CBS QDISC")
Signed-off-by: default avatarSong, Yoong Siang <yoong.siang.song@intel.com>
Link: https://lore.kernel.org/r/1613655653-11755-1-git-send-email-yoong.siang.song@intel.comSigned-off-by: default avatarJakub Kicinski <kuba@kernel.org>
parent e5bcf0e8
......@@ -316,6 +316,32 @@ static int tc_setup_cbs(struct stmmac_priv *priv,
if (!priv->dma_cap.av)
return -EOPNOTSUPP;
/* Port Transmit Rate and Speed Divider */
switch (priv->speed) {
case SPEED_10000:
ptr = 32;
speed_div = 10000000;
break;
case SPEED_5000:
ptr = 32;
speed_div = 5000000;
break;
case SPEED_2500:
ptr = 8;
speed_div = 2500000;
break;
case SPEED_1000:
ptr = 8;
speed_div = 1000000;
break;
case SPEED_100:
ptr = 4;
speed_div = 100000;
break;
default:
return -EOPNOTSUPP;
}
mode_to_use = priv->plat->tx_queues_cfg[queue].mode_to_use;
if (mode_to_use == MTL_QUEUE_DCB && qopt->enable) {
ret = stmmac_dma_qmode(priv, priv->ioaddr, queue, MTL_QUEUE_AVB);
......@@ -332,10 +358,6 @@ static int tc_setup_cbs(struct stmmac_priv *priv,
priv->plat->tx_queues_cfg[queue].mode_to_use = MTL_QUEUE_DCB;
}
/* Port Transmit Rate and Speed Divider */
ptr = (priv->speed == SPEED_100) ? 4 : 8;
speed_div = (priv->speed == SPEED_100) ? 100000 : 1000000;
/* Final adjustments for HW */
value = div_s64(qopt->idleslope * 1024ll * ptr, speed_div);
priv->plat->tx_queues_cfg[queue].idle_slope = value & GENMASK(31, 0);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment