bnxt_en: Wait longer for the firmware message response to complete.

[ Upstream commit 0000b81a ]

The code waits up to 20 usec for the firmware response to complete
once we've seen the valid response header in the buffer.  It turns
out that in some scenarios, this wait time is not long enough.
Extend it to 150 usec and use usleep_range() instead of udelay().

Fixes: 9751e8e7 ("bnxt_en: reduce timeout on initial HWRM calls")
Signed-off-by: Michael Chan <michael.chan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Sasha Levin <sashal@kernel.org>

drivers/net/ethernet/broadcom/bnxt/bnxt.c

@@ -3565,7 +3565,7 @@ static int bnxt_hwrm_do_send_msg(struct bnxt *bp, void *msg, u32 msg_len,
 			dma_rmb();
 			if (*valid)
 				break;
-			udelay(1);
+			usleep_range(1, 5);
 		}
 
 		if (j >= HWRM_VALID_BIT_DELAY_USEC) {

drivers/net/ethernet/broadcom/bnxt/bnxt.h

@@ -548,7 +548,7 @@ struct rx_tpa_end_cmp_ext {
 	(HWRM_SHORT_TIMEOUT_COUNTER * HWRM_SHORT_MIN_TIMEOUT +		\
 	 ((n) - HWRM_SHORT_TIMEOUT_COUNTER) * HWRM_MIN_TIMEOUT))
 
-#define HWRM_VALID_BIT_DELAY_USEC	20
+#define HWRM_VALID_BIT_DELAY_USEC	150
 
 #define BNXT_RX_EVENT	1
 #define BNXT_AGG_EVENT	2