Commit 2db3cff2 authored by Linus Torvalds's avatar Linus Torvalds

Merge tag 'mfd-fixes-3.17' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd

Pull mfd fixes from Lee Jones:
 "Couple of simple fixes due for the 3.17 rcs

  (and a sneaky document addition that slipped from the previous
  pull-request)"

* tag 'mfd-fixes-3.17' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd:
  mfd: twl4030-power: Fix PM idle pin configuration to not conflict with regulators
  mfd: tc3589x: Add device tree bindings
  mfd: ab8500-core: Use 'ifdef' for config options
  mfd: htc-i2cpld: Fix %d confusingly prefixed with 0x in format string
  mfd: omap-usb-host: Fix %d confusingly prefixed with 0x in format string
parents 0caf14e6 daebabd5
* Toshiba TC3589x multi-purpose expander
The Toshiba TC3589x series are I2C-based MFD devices which may expose the
following built-in devices: gpio, keypad, rotator (vibrator), PWM (for
e.g. LEDs or vibrators) The included models are:
- TC35890
- TC35892
- TC35893
- TC35894
- TC35895
- TC35896
Required properties:
- compatible : must be "toshiba,tc35890", "toshiba,tc35892", "toshiba,tc35893",
"toshiba,tc35894", "toshiba,tc35895" or "toshiba,tc35896"
- reg : I2C address of the device
- interrupt-parent : specifies which IRQ controller we're connected to
- interrupts : the interrupt on the parent the controller is connected to
- interrupt-controller : marks the device node as an interrupt controller
- #interrupt-cells : should be <1>, the first cell is the IRQ offset on this
TC3589x interrupt controller.
Optional nodes:
- GPIO
This GPIO module inside the TC3589x has 24 (TC35890, TC35892) or 20
(other models) GPIO lines.
- compatible : must be "toshiba,tc3589x-gpio"
- interrupts : interrupt on the parent, which must be the tc3589x MFD device
- interrupt-controller : marks the device node as an interrupt controller
- #interrupt-cells : should be <2>, the first cell is the IRQ offset on this
TC3589x GPIO interrupt controller, the second cell is the interrupt flags
in accordance with <dt-bindings/interrupt-controller/irq.h>. The following
flags are valid:
- IRQ_TYPE_LEVEL_LOW
- IRQ_TYPE_LEVEL_HIGH
- IRQ_TYPE_EDGE_RISING
- IRQ_TYPE_EDGE_FALLING
- IRQ_TYPE_EDGE_BOTH
- gpio-controller : marks the device node as a GPIO controller
- #gpio-cells : should be <2>, the first cell is the GPIO offset on this
GPIO controller, the second cell is the flags.
- Keypad
This keypad is the same on all variants, supporting up to 96 different
keys. The linux-specific properties are modeled on those already existing
in other input drivers.
- compatible : must be "toshiba,tc3589x-keypad"
- debounce-delay-ms : debounce interval in milliseconds
- keypad,num-rows : number of rows in the matrix, see
bindings/input/matrix-keymap.txt
- keypad,num-columns : number of columns in the matrix, see
bindings/input/matrix-keymap.txt
- linux,keymap: the definition can be found in
bindings/input/matrix-keymap.txt
- linux,no-autorepeat: do no enable autorepeat feature.
- linux,wakeup: use any event on keypad as wakeup event.
Example:
tc35893@44 {
compatible = "toshiba,tc35893";
reg = <0x44>;
interrupt-parent = <&gpio6>;
interrupts = <26 IRQ_TYPE_EDGE_RISING>;
interrupt-controller;
#interrupt-cells = <1>;
tc3589x_gpio {
compatible = "toshiba,tc3589x-gpio";
interrupts = <0>;
interrupt-controller;
#interrupt-cells = <2>;
gpio-controller;
#gpio-cells = <2>;
};
tc3589x_keypad {
compatible = "toshiba,tc3589x-keypad";
interrupts = <6>;
debounce-delay-ms = <4>;
keypad,num-columns = <8>;
keypad,num-rows = <8>;
linux,no-autorepeat;
linux,wakeup;
linux,keymap = <0x0301006b
0x04010066
0x06040072
0x040200d7
0x0303006a
0x0205000e
0x0607008b
0x0500001c
0x0403000b
0x03040034
0x05020067
0x0305006c
0x040500e7
0x0005009e
0x06020073
0x01030039
0x07060069
0x050500d9>;
};
};
......@@ -353,7 +353,7 @@ twl_audio: audio {
};
twl_power: power {
compatible = "ti,twl4030-power-n900";
compatible = "ti,twl4030-power-n900", "ti,twl4030-power-idle-osc-off";
ti,use_poweroff;
};
};
......
......@@ -1754,7 +1754,7 @@ static int ab8500_probe(struct platform_device *pdev)
if (ret)
return ret;
#if CONFIG_DEBUG_FS
#ifdef CONFIG_DEBUG_FS
/* Pass to debugfs */
ab8500_debug_resources[0].start = ab8500->irq;
ab8500_debug_resources[0].end = ab8500->irq;
......
......@@ -404,7 +404,7 @@ static int htcpld_register_chip_i2c(
}
i2c_set_clientdata(client, chip);
snprintf(client->name, I2C_NAME_SIZE, "Chip_0x%d", client->addr);
snprintf(client->name, I2C_NAME_SIZE, "Chip_0x%x", client->addr);
chip->client = client;
/* Reset the chip */
......
......@@ -647,7 +647,7 @@ static int usbhs_omap_probe(struct platform_device *pdev)
default:
omap->nports = OMAP3_HS_USB_PORTS;
dev_dbg(dev,
"USB HOST Rev:0x%d not recognized, assuming %d ports\n",
"USB HOST Rev:0x%x not recognized, assuming %d ports\n",
omap->usbhs_rev, omap->nports);
break;
}
......
......@@ -724,24 +724,24 @@ static struct twl4030_script *omap3_idle_scripts[] = {
* above.
*/
static struct twl4030_resconfig omap3_idle_rconfig[] = {
TWL_REMAP_SLEEP(RES_VAUX1, DEV_GRP_NULL, 0, 0),
TWL_REMAP_SLEEP(RES_VAUX2, DEV_GRP_NULL, 0, 0),
TWL_REMAP_SLEEP(RES_VAUX3, DEV_GRP_NULL, 0, 0),
TWL_REMAP_SLEEP(RES_VAUX4, DEV_GRP_NULL, 0, 0),
TWL_REMAP_SLEEP(RES_VMMC1, DEV_GRP_NULL, 0, 0),
TWL_REMAP_SLEEP(RES_VMMC2, DEV_GRP_NULL, 0, 0),
TWL_REMAP_SLEEP(RES_VAUX1, TWL4030_RESCONFIG_UNDEF, 0, 0),
TWL_REMAP_SLEEP(RES_VAUX2, TWL4030_RESCONFIG_UNDEF, 0, 0),
TWL_REMAP_SLEEP(RES_VAUX3, TWL4030_RESCONFIG_UNDEF, 0, 0),
TWL_REMAP_SLEEP(RES_VAUX4, TWL4030_RESCONFIG_UNDEF, 0, 0),
TWL_REMAP_SLEEP(RES_VMMC1, TWL4030_RESCONFIG_UNDEF, 0, 0),
TWL_REMAP_SLEEP(RES_VMMC2, TWL4030_RESCONFIG_UNDEF, 0, 0),
TWL_REMAP_OFF(RES_VPLL1, DEV_GRP_P1, 3, 1),
TWL_REMAP_SLEEP(RES_VPLL2, DEV_GRP_P1, 0, 0),
TWL_REMAP_SLEEP(RES_VSIM, DEV_GRP_NULL, 0, 0),
TWL_REMAP_SLEEP(RES_VDAC, DEV_GRP_NULL, 0, 0),
TWL_REMAP_SLEEP(RES_VSIM, TWL4030_RESCONFIG_UNDEF, 0, 0),
TWL_REMAP_SLEEP(RES_VDAC, TWL4030_RESCONFIG_UNDEF, 0, 0),
TWL_REMAP_SLEEP(RES_VINTANA1, TWL_DEV_GRP_P123, 1, 2),
TWL_REMAP_SLEEP(RES_VINTANA2, TWL_DEV_GRP_P123, 0, 2),
TWL_REMAP_SLEEP(RES_VINTDIG, TWL_DEV_GRP_P123, 1, 2),
TWL_REMAP_SLEEP(RES_VIO, TWL_DEV_GRP_P123, 2, 2),
TWL_REMAP_OFF(RES_VDD1, DEV_GRP_P1, 4, 1),
TWL_REMAP_OFF(RES_VDD2, DEV_GRP_P1, 3, 1),
TWL_REMAP_SLEEP(RES_VUSB_1V5, DEV_GRP_NULL, 0, 0),
TWL_REMAP_SLEEP(RES_VUSB_1V8, DEV_GRP_NULL, 0, 0),
TWL_REMAP_SLEEP(RES_VUSB_1V5, TWL4030_RESCONFIG_UNDEF, 0, 0),
TWL_REMAP_SLEEP(RES_VUSB_1V8, TWL4030_RESCONFIG_UNDEF, 0, 0),
TWL_REMAP_SLEEP(RES_VUSB_3V1, TWL_DEV_GRP_P123, 0, 0),
/* Resource #20 USB charge pump skipped */
TWL_REMAP_SLEEP(RES_REGEN, TWL_DEV_GRP_P123, 2, 1),
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment