Commit 30756cc1 authored by Tom Schwindl's avatar Tom Schwindl Committed by Bartosz Golaszewski

docs: driver-api: gpio: Fix filename mismatch

The filenames were changed a while ago, but board.rst, consumer.rst and
intro.rst still refer to the old names. Fix those references to match the
Actual names and avoid possible confusion.
Signed-off-by: default avatarTom Schwindl <schwindl@posteo.de>
Signed-off-by: default avatarBartosz Golaszewski <brgl@bgdev.pl>
parent 97a4087a
......@@ -6,7 +6,7 @@ This document explains how GPIOs can be assigned to given devices and functions.
Note that it only applies to the new descriptor-based interface. For a
description of the deprecated integer-based GPIO interface please refer to
gpio-legacy.txt (actually, there is no real mapping possible with the old
legacy.rst (actually, there is no real mapping possible with the old
interface; you just fetch an integer from somewhere and request the
corresponding GPIO).
......
......@@ -4,7 +4,7 @@ GPIO Descriptor Consumer Interface
This document describes the consumer interface of the GPIO framework. Note that
it describes the new descriptor-based interface. For a description of the
deprecated integer-based GPIO interface please refer to gpio-legacy.txt.
deprecated integer-based GPIO interface please refer to legacy.rst.
Guidelines for GPIOs consumers
......@@ -78,7 +78,7 @@ whether the line is configured active high or active low (see
The two last flags are used for use cases where open drain is mandatory, such
as I2C: if the line is not already configured as open drain in the mappings
(see board.txt), then open drain will be enforced anyway and a warning will be
(see board.rst), then open drain will be enforced anyway and a warning will be
printed that the board configuration needs to be updated to match the use case.
Both functions return either a valid GPIO descriptor, or an error code checkable
......@@ -270,7 +270,7 @@ driven.
The same is applicable for open drain or open source output lines: those do not
actively drive their output high (open drain) or low (open source), they just
switch their output to a high impedance value. The consumer should not need to
care. (For details read about open drain in driver.txt.)
care. (For details read about open drain in driver.rst.)
With this, all the gpiod_set_(array)_value_xxx() functions interpret the
parameter "value" as "asserted" ("1") or "de-asserted" ("0"). The physical line
......
......@@ -14,12 +14,12 @@ Due to the history of GPIO interfaces in the kernel, there are two different
ways to obtain and use GPIOs:
- The descriptor-based interface is the preferred way to manipulate GPIOs,
and is described by all the files in this directory excepted gpio-legacy.txt.
and is described by all the files in this directory excepted legacy.rst.
- The legacy integer-based interface which is considered deprecated (but still
usable for compatibility reasons) is documented in gpio-legacy.txt.
usable for compatibility reasons) is documented in legacy.rst.
The remainder of this document applies to the new descriptor-based interface.
gpio-legacy.txt contains the same information applied to the legacy
legacy.rst contains the same information applied to the legacy
integer-based interface.
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment