Commit 31b47ae3 authored by Hans de Goede's avatar Hans de Goede Committed by Rob Herring

devicetree: bindings: Extend the bma180 bindings with bma250 info

The bma180 / bma250 accelerometers share a driver (at least under Linux),
so it makes sense to also have their bindings info in a single .txt.

This commit extends the bma180 bindings with bma250 bindings, specifically
it specifies how the 2 seperate interrupts the bma250 has must be listed
in devicetree. The existing bma180 driver is already fully compatible
with the specified bindings.
Signed-off-by: default avatarHans de Goede <hdegoede@redhat.com>
Signed-off-by: default avatarRob Herring <robh@kernel.org>
parent 9fa04fbe
* Bosch BMA180 triaxial acceleration sensor * Bosch BMA180 / BMA250 triaxial acceleration sensor
http://omapworld.com/BMA180_111_1002839.pdf http://omapworld.com/BMA180_111_1002839.pdf
http://ae-bst.resource.bosch.com/media/products/dokumente/bma250/bst-bma250-ds002-05.pdf
Required properties: Required properties:
- compatible : should be "bosch,bma180" - compatible : should be "bosch,bma180" or "bosch,bma250"
- reg : the I2C address of the sensor - reg : the I2C address of the sensor
Optional properties: Optional properties:
...@@ -13,6 +14,9 @@ Optional properties: ...@@ -13,6 +14,9 @@ Optional properties:
- interrupts : interrupt mapping for GPIO IRQ, it should by configured with - interrupts : interrupt mapping for GPIO IRQ, it should by configured with
flags IRQ_TYPE_LEVEL_HIGH | IRQ_TYPE_EDGE_RISING flags IRQ_TYPE_LEVEL_HIGH | IRQ_TYPE_EDGE_RISING
For the bma250 the first interrupt listed must be the one
connected to the INT1 pin, the second (optional) interrupt
listed must be the one connected to the INT2 pin.
Example: Example:
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment