mtd: rawnand: davinci: Move the ECC initialization to ->attach_chip()

The probe function is only supposed to initialize the controller
hardware but not the ECC engine. Indeed, we don't know anything about
the NAND chip(s) at this stage. Let's move the logic initializing the
ECC engine, even pretty simple, to the ->attach_chip() hook which gets
called during nand_scan() routine, after the NAND chip discovery. As
the previously mentioned logic is supposed to parse the DT for us, it
is likely that the chip->ecc.* entries be overwritten. So let's avoid
this by moving these lines to ->attach_chip().

Fixes: d7157ff4 ("mtd: rawnand: Use the ECC framework user input parsing bits")
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Cc: Bartosz Golaszewski <bgolaszewski@baylibre.com>
Link: https://lore.kernel.org/linux-mtd/20201113123424.32233-7-miquel.raynal@bootlin.com

drivers/mtd/nand/raw/davinci_nand.c

@@ -585,6 +585,10 @@ static int davinci_nand_attach_chip(struct nand_chip *chip)
 	if (IS_ERR(pdata))
 		return PTR_ERR(pdata);
 
+	/* Use board-specific ECC config */
+	info->chip.ecc.engine_type = pdata->engine_type;
+	info->chip.ecc.placement = pdata->ecc_placement;
+
 	switch (info->chip.ecc.engine_type) {
 	case NAND_ECC_ENGINE_TYPE_NONE:
 		pdata->ecc_bits = 0;
@@ -850,10 +854,6 @@ static int nand_davinci_probe(struct platform_device *pdev)
 	info->mask_ale		= pdata->mask_ale ? : MASK_ALE;
 	info->mask_cle		= pdata->mask_cle ? : MASK_CLE;
 
-	/* Use board-specific ECC config */
-	info->chip.ecc.engine_type = pdata->engine_type;
-	info->chip.ecc.placement = pdata->ecc_placement;
-
 	spin_lock_irq(&davinci_nand_lock);
 
 	/* put CSxNAND into NAND mode */