Commit 3560741e authored by Zhilong Liu's avatar Zhilong Liu Committed by Shaohua Li

md: fix several trivial typos in comments

Signed-off-by: default avatarZhilong Liu <zlliu@suse.com>
Signed-off-by: default avatarShaohua Li <shli@fb.com>
parent 27f26a0f
......@@ -697,7 +697,7 @@ static int bitmap_read_sb(struct bitmap *bitmap)
out:
kunmap_atomic(sb);
/* Assiging chunksize is required for "re_read" */
/* Assigning chunksize is required for "re_read" */
bitmap->mddev->bitmap_info.chunksize = chunksize;
if (err == 0 && nodes && (bitmap->cluster_slot < 0)) {
err = md_setup_cluster(bitmap->mddev, nodes);
......
......@@ -2296,7 +2296,7 @@ static int resize_stripes(struct r5conf *conf, int newsize)
* pages have been transferred over, and the old kmem_cache is
* freed when all stripes are done.
* 3/ reallocate conf->disks to be suitable bigger. If this fails,
* we simple return a failre status - no need to clean anything up.
* we simple return a failure status - no need to clean anything up.
* 4/ allocate new pages for the new slots in the new stripe_heads.
* If this fails, we don't bother trying the shrink the
* stripe_heads down again, we just leave them as they are.
......@@ -3558,7 +3558,7 @@ static int need_this_block(struct stripe_head *sh, struct stripe_head_state *s,
!test_bit(STRIPE_PREREAD_ACTIVE, &sh->state))
/* Pre-reads at not permitted until after short delay
* to gather multiple requests. However if this
* device is no Insync, the block could only be be computed
* device is no Insync, the block could only be computed
* and there is no need to delay that.
*/
return 0;
......@@ -3577,7 +3577,7 @@ static int need_this_block(struct stripe_head *sh, struct stripe_head_state *s,
/* If we are forced to do a reconstruct-write, either because
* the current RAID6 implementation only supports that, or
* or because parity cannot be trusted and we are currently
* because parity cannot be trusted and we are currently
* recovering it, there is extra need to be careful.
* If one of the devices that we would need to read, because
* it is not being overwritten (and maybe not written at all)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment