via-velocity: Give RX descriptors to the NIC later on open or MTU change

velocity_open() calls velocity_give_many_rx_descs(), which gives RX
descriptors to the NIC, before installing an interrupt handler or
calling velocity_init_registers().  I think this is very unsafe and it
appears to explain the bug report <http://bugs.debian.org/508527>.

On MTU change, velocity_give_many_rx_descs() is again called before
velocity_init_registers().  I'm not sure whether this is unsafe but
it does look wrong.

Therefore, move the calls to velocity_give_many_rx_descs() after
request_irq() and velocity_init_registers().
Signed-off-by: Ben Hutchings <ben@decadent.org.uk>
Tested-by: Jan Ceuleers <jan.ceuleers@computer.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/via-velocity.c

@@ -2237,8 +2237,6 @@ static int velocity_open(struct net_device *dev)
 	/* Ensure chip is running */
 	pci_set_power_state(vptr->pdev, PCI_D0);
 
-	velocity_give_many_rx_descs(vptr);
-
 	velocity_init_registers(vptr, VELOCITY_INIT_COLD);
 
 	ret = request_irq(vptr->pdev->irq, velocity_intr, IRQF_SHARED,
@@ -2250,6 +2248,8 @@ static int velocity_open(struct net_device *dev)
 		goto out;
 	}
 
+	velocity_give_many_rx_descs(vptr);
+
 	mac_enable_int(vptr->mac_regs);
 	netif_start_queue(dev);
 	napi_enable(&vptr->napi);
@@ -2339,10 +2339,10 @@ static int velocity_change_mtu(struct net_device *dev, int new_mtu)
 
 		dev->mtu = new_mtu;
 
-		velocity_give_many_rx_descs(vptr);
-
 		velocity_init_registers(vptr, VELOCITY_INIT_COLD);
 
+		velocity_give_many_rx_descs(vptr);
+
 		mac_enable_int(vptr->mac_regs);
 		netif_start_queue(dev);