Commit 3619ac02 authored by Thomas Petazzoni's avatar Thomas Petazzoni Committed by Jason Cooper

Documentation: add description of DT binding for the gpio-mvebu driver

Signed-off-by: default avatarThomas Petazzoni <thomas.petazzoni@free-electrons.com>
Acked-by: default avatarLinus Walleij <linus.walleij@linaro.org>
Cc: Grant Likely <grant.likely@secretlab.ca>
Cc: Linus Walleij <linus.walleij@stericsson.com>
Cc: Andrew Lunn <andrew@lunn.ch>
Cc: Jason Cooper <jason@lakedaemon.net>
Cc: Gregory Clement <gregory.clement@free-electrons.com>
Acked-by: default avatarRob Herring <rob.herring@calxeda.com>
Acked-by: default avatarArnd Bergmann <arnd@arndb.de>
Signed-off-by: default avatarJason Cooper <jason@lakedaemon.net>
parent fefe7b09
* Marvell EBU GPIO controller
Required properties:
- compatible : Should be "marvell,orion-gpio", "marvell,mv78200-gpio"
or "marvell,armadaxp-gpio". "marvell,orion-gpio" should be used for
Orion, Kirkwood, Dove, Discovery (except MV78200) and Armada
370. "marvell,mv78200-gpio" should be used for the Discovery
MV78200. "marvel,armadaxp-gpio" should be used for all Armada XP
SoCs (MV78230, MV78260, MV78460).
- reg: Address and length of the register set for the device. Only one
entry is expected, except for the "marvell,armadaxp-gpio" variant
for which two entries are expected: one for the general registers,
one for the per-cpu registers.
- interrupts: The list of interrupts that are used for all the pins
managed by this GPIO bank. There can be more than one interrupt
(example: 1 interrupt per 8 pins on Armada XP, which means 4
interrupts per bank of 32 GPIOs).
- interrupt-controller: identifies the node as an interrupt controller
- #interrupt-cells: specifies the number of cells needed to encode an
interrupt source. Should be two.
The first cell is the GPIO number.
The second cell is used to specify flags:
bits[3:0] trigger type and level flags:
1 = low-to-high edge triggered.
2 = high-to-low edge triggered.
4 = active high level-sensitive.
8 = active low level-sensitive.
- gpio-controller: marks the device node as a gpio controller
- ngpios: number of GPIOs this controller has
- #gpio-cells: Should be two. The first cell is the pin number. The
second cell is reserved for flags, unused at the moment.
Example:
gpio0: gpio@d0018100 {
compatible = "marvell,armadaxp-gpio";
reg = <0xd0018100 0x40>,
<0xd0018800 0x30>;
ngpios = <32>;
gpio-controller;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
interrupts = <16>, <17>, <18>, <19>;
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment