Commit 36b5d460 authored by Brian Norris's avatar Brian Norris Committed by Ulf Hansson

phy: rockchip-emmc: configure default output tap delay

The output tap delay controls helps maintain the hold requirements for
eMMC. The exact value is dependent on the SoC and other factors, though
it isn't really an exact science. But the default of 0 is not very good,
as it doesn't give the eMMC much hold time, so let's bump up to 4
(approx 90 degree phase?). If we need to configure this any further
(e.g., based on board or speed factors), we may need to consider a
device tree representation.
Suggested-by: default avatarShawn Lin <shawn.lin@rock-chips.com>
Signed-off-by: default avatarBrian Norris <briannorris@chromium.org>
Signed-off-by: default avatarDouglas Anderson <dianders@chromium.org>
Acked-by: default avatarKishon Vijay Abraham I <kishon@ti.com>
Tested-by: default avatarHeiko Stuebner <heiko@sntech.de>
Signed-off-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
parent d7485772
......@@ -69,6 +69,11 @@
#define PHYCTRL_DR_66OHM 0x2
#define PHYCTRL_DR_100OHM 0x3
#define PHYCTRL_DR_40OHM 0x4
#define PHYCTRL_OTAPDLYENA 0x1
#define PHYCTRL_OTAPDLYENA_MASK 0x1
#define PHYCTRL_OTAPDLYENA_SHIFT 0xb
#define PHYCTRL_OTAPDLYSEL_MASK 0xf
#define PHYCTRL_OTAPDLYSEL_SHIFT 0x7
struct rockchip_emmc_phy {
unsigned int reg_offset;
......@@ -181,6 +186,20 @@ static int rockchip_emmc_phy_power_on(struct phy *phy)
PHYCTRL_DR_MASK,
PHYCTRL_DR_SHIFT));
/* Output tap delay: enable */
regmap_write(rk_phy->reg_base,
rk_phy->reg_offset + GRF_EMMCPHY_CON0,
HIWORD_UPDATE(PHYCTRL_OTAPDLYENA,
PHYCTRL_OTAPDLYENA_MASK,
PHYCTRL_OTAPDLYENA_SHIFT));
/* Output tap delay */
regmap_write(rk_phy->reg_base,
rk_phy->reg_offset + GRF_EMMCPHY_CON0,
HIWORD_UPDATE(4,
PHYCTRL_OTAPDLYSEL_MASK,
PHYCTRL_OTAPDLYSEL_SHIFT));
/* Power up emmc phy analog blocks */
ret = rockchip_emmc_phy_power(rk_phy, PHYCTRL_PDB_PWR_ON);
if (ret)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment