Skip to content

L
linux
Commit 3919357f authored by Antoine Ténart's avatar Antoine Ténart Committed by David S. Miller
1 Browse files
Options

net: mvpp2: initialize the GMAC when using a port 

This adds a routine to initialize the GMAC at the port level when using
a port. This wasn't done until this commit, and the mvpp2 driver was
relying on the bootloader/firmware initialization. This doesn't mean
everything is configured in the mvpp2 driver now, but it helps reducing
the gap.
Signed-off-by: default avatarAntoine Tenart <antoine.tenart@free-electrons.com>
Tested-by: default avatarMarcin Wojtas <mw@semihalf.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 2055d626
Hide whitespace changes
Inline Side-by-side
Showing with 98 additions and 25 deletions
drivers/net/ethernet/marvell/mvpp2.c
View file @ 3919357f
......@@ -315,6 +315,7 @@
/* Per-port registers */
#define MVPP2_GMAC_CTRL_0_REG 0x0
#define MVPP2_GMAC_PORT_EN_MASK BIT(0)
#define MVPP2_GMAC_PORT_TYPE_MASK BIT(1)
#define MVPP2_GMAC_MAX_RX_SIZE_OFFS 2
#define MVPP2_GMAC_MAX_RX_SIZE_MASK 0x7ffc
#define MVPP2_GMAC_MIB_CNTR_EN_MASK BIT(15)
......@@ -326,16 +327,21 @@
#define MVPP2_GMAC_SA_LOW_OFFS 7
#define MVPP2_GMAC_CTRL_2_REG 0x8
#define MVPP2_GMAC_INBAND_AN_MASK BIT(0)
#define MVPP2_GMAC_FLOW_CTRL_MASK GENMASK(2, 1)
#define MVPP2_GMAC_PCS_ENABLE_MASK BIT(3)
#define MVPP2_GMAC_PORT_RGMII_MASK BIT(4)
#define MVPP2_GMAC_DISABLE_PADDING BIT(5)
#define MVPP2_GMAC_PORT_RESET_MASK BIT(6)
#define MVPP2_GMAC_AUTONEG_CONFIG 0xc
#define MVPP2_GMAC_FORCE_LINK_DOWN BIT(0)
#define MVPP2_GMAC_FORCE_LINK_PASS BIT(1)
#define MVPP2_GMAC_IN_BAND_AUTONEG BIT(2)
#define MVPP2_GMAC_IN_BAND_AUTONEG_BYPASS BIT(3)
#define MVPP2_GMAC_CONFIG_MII_SPEED BIT(5)
#define MVPP2_GMAC_CONFIG_GMII_SPEED BIT(6)
#define MVPP2_GMAC_AN_SPEED_EN BIT(7)
#define MVPP2_GMAC_FC_ADV_EN BIT(9)
#define MVPP2_GMAC_FLOW_CTRL_AUTONEG BIT(11)
#define MVPP2_GMAC_CONFIG_FULL_DUPLEX BIT(12)
#define MVPP2_GMAC_AN_DUPLEX_EN BIT(13)
#define MVPP2_GMAC_PORT_FIFO_CFG_1_REG 0x1c
......@@ -4245,6 +4251,92 @@ mvpp2_shared_interrupt_mask_unmask(struct mvpp2_port *port, bool mask)
/* Port configuration routines */
static void mvpp2_port_mii_gmac_configure_mode(struct mvpp2_port *port)
{
u32 val;
if (port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
val = readl(port->base + MVPP22_GMAC_CTRL_4_REG);
val |= MVPP22_CTRL4_SYNC_BYPASS_DIS | MVPP22_CTRL4_DP_CLK_SEL |
MVPP22_CTRL4_QSGMII_BYPASS_ACTIVE;
val &= ~MVPP22_CTRL4_EXT_PIN_GMII_SEL;
writel(val, port->base + MVPP22_GMAC_CTRL_4_REG);
val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
val |= MVPP2_GMAC_DISABLE_PADDING;
val &= ~MVPP2_GMAC_FLOW_CTRL_MASK;
writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
} else if (port->phy_interface == PHY_INTERFACE_MODE_RGMII ||
port->phy_interface == PHY_INTERFACE_MODE_RGMII_ID ||
port->phy_interface == PHY_INTERFACE_MODE_RGMII_RXID ||
port->phy_interface == PHY_INTERFACE_MODE_RGMII_TXID) {
val = readl(port->base + MVPP22_GMAC_CTRL_4_REG);
val |= MVPP22_CTRL4_EXT_PIN_GMII_SEL |
MVPP22_CTRL4_SYNC_BYPASS_DIS |
MVPP22_CTRL4_QSGMII_BYPASS_ACTIVE;
val &= ~MVPP22_CTRL4_DP_CLK_SEL;
writel(val, port->base + MVPP22_GMAC_CTRL_4_REG);
val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
val &= ~MVPP2_GMAC_DISABLE_PADDING;
writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
}
/* The port is connected to a copper PHY */
val = readl(port->base + MVPP2_GMAC_CTRL_0_REG);
val &= ~MVPP2_GMAC_PORT_TYPE_MASK;
writel(val, port->base + MVPP2_GMAC_CTRL_0_REG);
val = readl(port->base + MVPP2_GMAC_AUTONEG_CONFIG);
val |= MVPP2_GMAC_IN_BAND_AUTONEG_BYPASS |
MVPP2_GMAC_AN_SPEED_EN | MVPP2_GMAC_FLOW_CTRL_AUTONEG |
MVPP2_GMAC_AN_DUPLEX_EN;
if (port->phy_interface == PHY_INTERFACE_MODE_SGMII)
val |= MVPP2_GMAC_IN_BAND_AUTONEG;
writel(val, port->base + MVPP2_GMAC_AUTONEG_CONFIG);
}
static void mvpp2_port_mii_gmac_configure(struct mvpp2_port *port)
{
u32 val;
/* Force link down */
val = readl(port->base + MVPP2_GMAC_AUTONEG_CONFIG);
val &= ~MVPP2_GMAC_FORCE_LINK_PASS;
val |= MVPP2_GMAC_FORCE_LINK_DOWN;
writel(val, port->base + MVPP2_GMAC_AUTONEG_CONFIG);
/* Set the GMAC in a reset state */
val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
val |= MVPP2_GMAC_PORT_RESET_MASK;
writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
/* Configure the PCS and in-band AN */
val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
if (port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
val |= MVPP2_GMAC_INBAND_AN_MASK | MVPP2_GMAC_PCS_ENABLE_MASK;
} else if (port->phy_interface == PHY_INTERFACE_MODE_RGMII ||
port->phy_interface == PHY_INTERFACE_MODE_RGMII_ID ||
port->phy_interface == PHY_INTERFACE_MODE_RGMII_RXID ||
port->phy_interface == PHY_INTERFACE_MODE_RGMII_TXID) {
val &= ~MVPP2_GMAC_PCS_ENABLE_MASK;
val |= MVPP2_GMAC_PORT_RGMII_MASK;
}
writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
mvpp2_port_mii_gmac_configure_mode(port);
/* Unset the GMAC reset state */
val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
val &= ~MVPP2_GMAC_PORT_RESET_MASK;
writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
/* Stop forcing link down */
val = readl(port->base + MVPP2_GMAC_AUTONEG_CONFIG);
val &= ~MVPP2_GMAC_FORCE_LINK_DOWN;
writel(val, port->base + MVPP2_GMAC_AUTONEG_CONFIG);
}
static void mvpp22_port_mii_set(struct mvpp2_port *port)
{
u32 val;
......@@ -4262,38 +4354,19 @@ static void mvpp22_port_mii_set(struct mvpp2_port *port)
writel(val, port->base + MVPP22_XLG_CTRL3_REG);
}
val = readl(port->base + MVPP22_GMAC_CTRL_4_REG);
if (port->phy_interface == PHY_INTERFACE_MODE_RGMII)
val |= MVPP22_CTRL4_EXT_PIN_GMII_SEL;
else
val &= ~MVPP22_CTRL4_EXT_PIN_GMII_SEL;
val &= ~MVPP22_CTRL4_DP_CLK_SEL;
val |= MVPP22_CTRL4_SYNC_BYPASS_DIS;
val |= MVPP22_CTRL4_QSGMII_BYPASS_ACTIVE;
writel(val, port->base + MVPP22_GMAC_CTRL_4_REG);
}
static void mvpp2_port_mii_set(struct mvpp2_port *port)
{
u32 val;
if (port->priv->hw_version == MVPP22)
mvpp22_port_mii_set(port);
val = readl(port->base + MVPP2_GMAC_CTRL_2_REG);
switch (port->phy_interface) {
case PHY_INTERFACE_MODE_SGMII:
val |= MVPP2_GMAC_INBAND_AN_MASK;
break;
case PHY_INTERFACE_MODE_RGMII:
val |= MVPP2_GMAC_PORT_RGMII_MASK;
default:
val &= ~MVPP2_GMAC_PCS_ENABLE_MASK;
}
writel(val, port->base + MVPP2_GMAC_CTRL_2_REG);
if (port->phy_interface == PHY_INTERFACE_MODE_RGMII ||
port->phy_interface == PHY_INTERFACE_MODE_RGMII_ID ||
port->phy_interface == PHY_INTERFACE_MODE_RGMII_RXID ||
port->phy_interface == PHY_INTERFACE_MODE_RGMII_TXID ||
port->phy_interface == PHY_INTERFACE_MODE_SGMII)
mvpp2_port_mii_gmac_configure(port);
}
static void mvpp2_port_fc_adv_enable(struct mvpp2_port *port)
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment
GitLab Nexedi Edition | About GitLab | About Nexedi | 沪ICP备2021021310号-2 | 沪ICP备2021021310号-7