Commit 391e53e3 authored by Antonio Quartulli's avatar Antonio Quartulli Committed by Johannes Berg

mac80211: implement set_mcast_rate() callback

This new callback can be used to tune the rate to be used to send
multicast frames.

In the current state the multicast rate can be specified on IBSS/MESH
joining only. This makes it impossible to select a custom multicast
rate when then join command is sent by an external program (e.g.
wpa_supplicant)
Signed-off-by: default avatarAntonio Quartulli <ordex@autistici.org>
Signed-off-by: default avatarJohannes Berg <johannes.berg@intel.com>
parent f4e583c8
......@@ -1954,6 +1954,16 @@ static int ieee80211_leave_ibss(struct wiphy *wiphy, struct net_device *dev)
return ieee80211_ibss_leave(IEEE80211_DEV_TO_SUB_IF(dev));
}
static int ieee80211_set_mcast_rate(struct wiphy *wiphy, struct net_device *dev,
int rate[IEEE80211_NUM_BANDS])
{
struct ieee80211_sub_if_data *sdata = IEEE80211_DEV_TO_SUB_IF(dev);
memcpy(sdata->vif.bss_conf.mcast_rate, rate, sizeof(rate));
return 0;
}
static int ieee80211_set_wiphy_params(struct wiphy *wiphy, u32 changed)
{
struct ieee80211_local *local = wiphy_priv(wiphy);
......@@ -3180,6 +3190,7 @@ struct cfg80211_ops mac80211_config_ops = {
.disassoc = ieee80211_disassoc,
.join_ibss = ieee80211_join_ibss,
.leave_ibss = ieee80211_leave_ibss,
.set_mcast_rate = ieee80211_set_mcast_rate,
.set_wiphy_params = ieee80211_set_wiphy_params,
.set_tx_power = ieee80211_set_tx_power,
.get_tx_power = ieee80211_get_tx_power,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment