Commit 3b0fb97c authored by Shubhrajyoti D's avatar Shubhrajyoti D Committed by Wolfram Sang

I2C: OMAP: Handle error check for pm runtime

If PM runtime get_sync fails return with the error
so that no further reads/writes goes through the interface.
This will avoid possible abort. Add a error message in case
of failure with the cause of the failure.
Reviewed-by: default avatarKevin Hilman <khilman@ti.com>
Signed-off-by: default avatarShubhrajyoti D <shubhrajyoti@ti.com>
Signed-off-by: default avatarWolfram Sang <w.sang@pengutronix.de>
parent 0861f430
......@@ -585,7 +585,9 @@ omap_i2c_xfer(struct i2c_adapter *adap, struct i2c_msg msgs[], int num)
int i;
int r;
pm_runtime_get_sync(dev->dev);
r = pm_runtime_get_sync(dev->dev);
if (IS_ERR_VALUE(r))
return r;
r = omap_i2c_wait_for_bb(dev);
if (r < 0)
......@@ -1011,7 +1013,9 @@ omap_i2c_probe(struct platform_device *pdev)
dev->regs = (u8 *)reg_map_ip_v1;
pm_runtime_enable(dev->dev);
pm_runtime_get_sync(dev->dev);
r = pm_runtime_get_sync(dev->dev);
if (IS_ERR_VALUE(r))
goto err_free_mem;
dev->rev = omap_i2c_read_reg(dev, OMAP_I2C_REV_REG) & 0xff;
......@@ -1103,12 +1107,16 @@ omap_i2c_remove(struct platform_device *pdev)
{
struct omap_i2c_dev *dev = platform_get_drvdata(pdev);
struct resource *mem;
int ret;
platform_set_drvdata(pdev, NULL);
free_irq(dev->irq, dev);
i2c_del_adapter(&dev->adapter);
pm_runtime_get_sync(&pdev->dev);
ret = pm_runtime_get_sync(&pdev->dev);
if (IS_ERR_VALUE(ret))
return ret;
omap_i2c_write_reg(dev, OMAP_I2C_CON_REG, 0);
pm_runtime_put(&pdev->dev);
pm_runtime_disable(&pdev->dev);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment