Commit 3b792c86 authored by Mirza Krak's avatar Mirza Krak Committed by Greg Kroah-Hartman

can: sja1000: clear interrupts on start

commit 7cecd9ab upstream.

According to SJA1000 data sheet error-warning (EI) interrupt is not
cleared by setting the controller in to reset-mode.

Then if we have the following case:
- system is suspended (echo mem > /sys/power/state) and SJA1000 is left
  in operating state
- A bus error condition occurs which activates EI interrupt, system is
  still suspended which means EI interrupt will be not be handled nor
  cleared.

If the above two events occur, on resume there is no way to return the
SJA1000 to operating state, except to cycle power to it.

By simply reading the IR register on start we will clear any previous
conditions that could be present.
Signed-off-by: default avatarMirza Krak <mirza.krak@hostmobility.com>
Reported-by: default avatarChristian Magnusson <Christian.Magnusson@semcon.com>
Signed-off-by: default avatarMarc Kleine-Budde <mkl@pengutronix.de>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent c4582077
...@@ -184,6 +184,9 @@ static void sja1000_start(struct net_device *dev) ...@@ -184,6 +184,9 @@ static void sja1000_start(struct net_device *dev)
priv->write_reg(priv, SJA1000_RXERR, 0x0); priv->write_reg(priv, SJA1000_RXERR, 0x0);
priv->read_reg(priv, SJA1000_ECC); priv->read_reg(priv, SJA1000_ECC);
/* clear interrupt flags */
priv->read_reg(priv, SJA1000_IR);
/* leave reset mode */ /* leave reset mode */
set_normal_mode(dev); set_normal_mode(dev);
} }
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment