net: bcmgenet: Add support for 7712 16nm internal EPHY

The 16nm internal EPHY that is present in 7712 is actually a 16nm
Gigabit PHY which has been forced to operate in 10/100 mode. Its
controls are therefore via the EXT_GPHY_CTRL registers and not via the
EXT_EPHY_CTRL which are used for all GENETv5 adapters. Add a match on
the 7712 compatible string to allow that differentiation to happen.

On previous GENETv4 chips the EXT_CFG_IDDQ_GLOBAL_PWR bit was cleared by
default, but this is not the case with this chip, so we need to make
sure we clear it to power on the EPHY.
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/genet/bcmgenet.c

@@ -1653,7 +1653,7 @@ static int bcmgenet_power_down(struct bcmgenet_priv *priv,
 		/* Power down LED */
 		if (priv->hw_params->flags & GENET_HAS_EXT) {
 			reg = bcmgenet_ext_readl(priv, EXT_EXT_PWR_MGMT);
-			if (GENET_IS_V5(priv))
+			if (GENET_IS_V5(priv) && !priv->ephy_16nm)
 				reg |= EXT_PWR_DOWN_PHY_EN |
 				       EXT_PWR_DOWN_PHY_RD |
 				       EXT_PWR_DOWN_PHY_SD |
@@ -1690,7 +1690,7 @@ static void bcmgenet_power_up(struct bcmgenet_priv *priv,
 	case GENET_POWER_PASSIVE:
 		reg &= ~(EXT_PWR_DOWN_DLL | EXT_PWR_DOWN_BIAS |
 			 EXT_ENERGY_DET_MASK);
-		if (GENET_IS_V5(priv)) {
+		if (GENET_IS_V5(priv) && !priv->ephy_16nm) {
 			reg &= ~(EXT_PWR_DOWN_PHY_EN |
 				 EXT_PWR_DOWN_PHY_RD |
 				 EXT_PWR_DOWN_PHY_SD |
@@ -3910,6 +3910,7 @@ static void bcmgenet_set_hw_params(struct bcmgenet_priv *priv)
 struct bcmgenet_plat_data {
 	enum bcmgenet_version version;
 	u32 dma_max_burst_length;
+	bool ephy_16nm;
 };
 
 static const struct bcmgenet_plat_data v1_plat_data = {
@@ -3942,6 +3943,12 @@ static const struct bcmgenet_plat_data bcm2711_plat_data = {
 	.dma_max_burst_length = 0x08,
 };
 
+static const struct bcmgenet_plat_data bcm7712_plat_data = {
+	.version = GENET_V5,
+	.dma_max_burst_length = DMA_MAX_BURST_LENGTH,
+	.ephy_16nm = true,
+};
+
 static const struct of_device_id bcmgenet_match[] = {
 	{ .compatible = "brcm,genet-v1", .data = &v1_plat_data },
 	{ .compatible = "brcm,genet-v2", .data = &v2_plat_data },
@@ -3949,6 +3956,7 @@ static const struct of_device_id bcmgenet_match[] = {
 	{ .compatible = "brcm,genet-v4", .data = &v4_plat_data },
 	{ .compatible = "brcm,genet-v5", .data = &v5_plat_data },
 	{ .compatible = "brcm,bcm2711-genet-v5", .data = &bcm2711_plat_data },
+	{ .compatible = "brcm,bcm7712-genet-v5", .data = &bcm7712_plat_data },
 	{ },
 };
 MODULE_DEVICE_TABLE(of, bcmgenet_match);
@@ -4029,6 +4037,7 @@ static int bcmgenet_probe(struct platform_device *pdev)
 	if (pdata) {
 		priv->version = pdata->version;
 		priv->dma_max_burst_length = pdata->dma_max_burst_length;
+		priv->ephy_16nm = pdata->ephy_16nm;
 	} else {
 		priv->version = pd->genet_version;
 		priv->dma_max_burst_length = DMA_MAX_BURST_LENGTH;

drivers/net/ethernet/broadcom/genet/bcmgenet.h

@@ -329,6 +329,7 @@ struct bcmgenet_mib_counters {
 #define  EXT_CFG_IDDQ_BIAS		(1 << 0)
 #define  EXT_CFG_PWR_DOWN		(1 << 1)
 #define  EXT_CK25_DIS			(1 << 4)
+#define  EXT_CFG_IDDQ_GLOBAL_PWR	(1 << 3)
 #define  EXT_GPHY_RESET			(1 << 5)
 
 /* DMA rings size */
@@ -612,6 +613,7 @@ struct bcmgenet_priv {
 	phy_interface_t phy_interface;
 	int phy_addr;
 	int ext_phy;
+	bool ephy_16nm;
 
 	/* Interrupt variables */
 	struct work_struct bcmgenet_irq_work;

drivers/net/ethernet/broadcom/genet/bcmmii.c

@@ -139,14 +139,15 @@ void bcmgenet_phy_power_set(struct net_device *dev, bool enable)
 	u32 reg = 0;
 
 	/* EXT_GPHY_CTRL is only valid for GENETv4 and onward */
-	if (GENET_IS_V4(priv)) {
+	if (GENET_IS_V4(priv) || priv->ephy_16nm) {
 		reg = bcmgenet_ext_readl(priv, EXT_GPHY_CTRL);
 		if (enable) {
 			reg &= ~EXT_CK25_DIS;
 			bcmgenet_ext_writel(priv, reg, EXT_GPHY_CTRL);
 			mdelay(1);
 
-			reg &= ~(EXT_CFG_IDDQ_BIAS | EXT_CFG_PWR_DOWN);
+			reg &= ~(EXT_CFG_IDDQ_BIAS | EXT_CFG_PWR_DOWN |
+				 EXT_CFG_IDDQ_GLOBAL_PWR);
 			reg |= EXT_GPHY_RESET;
 			bcmgenet_ext_writel(priv, reg, EXT_GPHY_CTRL);
 			mdelay(1);
@@ -154,7 +155,7 @@ void bcmgenet_phy_power_set(struct net_device *dev, bool enable)
 			reg &= ~EXT_GPHY_RESET;
 		} else {
 			reg |= EXT_CFG_IDDQ_BIAS | EXT_CFG_PWR_DOWN |
-			       EXT_GPHY_RESET;
+			       EXT_GPHY_RESET | EXT_CFG_IDDQ_GLOBAL_PWR;
 			bcmgenet_ext_writel(priv, reg, EXT_GPHY_CTRL);
 			mdelay(1);
 			reg |= EXT_CK25_DIS;