Commit 3cf86452 authored by Ondrej Zary's avatar Ondrej Zary Committed by Tejun Heo

sata_via: Enable hotplug only on VT6421

Commit 57e5568f ("sata_via: Implement hotplug for VT6421") adds
hotplug IRQ handler for VT6421 but enables hotplug on all chips. This
is a bug because it causes "irq xx: nobody cared" error on VT6420 when
hot-(un)plugging a drive:

[  381.839948] irq 20: nobody cared (try booting with the "irqpoll" option)
[  381.840014] CPU: 0 PID: 0 Comm: swapper/0 Not tainted 4.10.0-rc5+ #148
[  381.840066] Hardware name:          P4VM800/P4VM800, BIOS P1.60 05/29/2006
[  381.840117] Call Trace:
[  381.840167]  <IRQ>
[  381.840225]  ? dump_stack+0x44/0x58
[  381.840278]  ? __report_bad_irq+0x14/0x97
[  381.840327]  ? handle_edge_irq+0xa5/0xa5
[  381.840376]  ? note_interrupt+0x155/0x1cf
[  381.840426]  ? handle_edge_irq+0xa5/0xa5
[  381.840474]  ? handle_irq_event_percpu+0x32/0x38
[  381.840524]  ? handle_irq_event+0x1f/0x38
[  381.840573]  ? handle_fasteoi_irq+0x69/0xb8
[  381.840625]  ? handle_irq+0x4f/0x5d
[  381.840672]  </IRQ>
[  381.840726]  ? do_IRQ+0x2e/0x8b
[  381.840782]  ? common_interrupt+0x2c/0x34
[  381.840836]  ? mwait_idle+0x60/0x82
[  381.840892]  ? arch_cpu_idle+0x6/0x7
[  381.840949]  ? do_idle+0x96/0x18e
[  381.841002]  ? cpu_startup_entry+0x16/0x1a
[  381.841057]  ? start_kernel+0x319/0x31c
[  381.841111]  ? startup_32_smp+0x166/0x168
[  381.841165] handlers:
[  381.841219] [<c12a7263>] ata_bmdma_interrupt
[  381.841274] Disabling IRQ #20

Seems that VT6420 can do hotplug too (there's no documentation) but the
comments say that SCR register access (required for detecting hotplug
events) can cause problems on these chips.

For now, just keep hotplug disabled on anything other than VT6421.
Signed-off-by: default avatarOndrej Zary <linux@rainbow-software.org>
Signed-off-by: default avatarTejun Heo <tj@kernel.org>
parent a431ecd2
...@@ -644,14 +644,16 @@ static void svia_configure(struct pci_dev *pdev, int board_id, ...@@ -644,14 +644,16 @@ static void svia_configure(struct pci_dev *pdev, int board_id,
pci_write_config_byte(pdev, SATA_NATIVE_MODE, tmp8); pci_write_config_byte(pdev, SATA_NATIVE_MODE, tmp8);
} }
/* enable IRQ on hotplug */ if (board_id == vt6421) {
pci_read_config_byte(pdev, SVIA_MISC_3, &tmp8); /* enable IRQ on hotplug */
if ((tmp8 & SATA_HOTPLUG) != SATA_HOTPLUG) { pci_read_config_byte(pdev, SVIA_MISC_3, &tmp8);
dev_dbg(&pdev->dev, if ((tmp8 & SATA_HOTPLUG) != SATA_HOTPLUG) {
"enabling SATA hotplug (0x%x)\n", dev_dbg(&pdev->dev,
(int) tmp8); "enabling SATA hotplug (0x%x)\n",
tmp8 |= SATA_HOTPLUG; (int) tmp8);
pci_write_config_byte(pdev, SVIA_MISC_3, tmp8); tmp8 |= SATA_HOTPLUG;
pci_write_config_byte(pdev, SVIA_MISC_3, tmp8);
}
} }
/* /*
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment