crypto: atmel - use the correct print format

According to Documentation/core-api/printk-formats.rst, Use
the correct print format. Printing an unsigned int value should use %u
instead of %d.
Signed-off-by: Kai Ye <yekai13@huawei.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>

drivers/crypto/atmel-i2c.c

@@ -339,7 +339,7 @@ int atmel_i2c_probe(struct i2c_client *client, const struct i2c_device_id *id)
 	}
 
 	if (bus_clk_rate > 1000000L) {
-		dev_err(dev, "%d exceeds maximum supported clock frequency (1MHz)\n",
+		dev_err(dev, "%u exceeds maximum supported clock frequency (1MHz)\n",
 			bus_clk_rate);
 		return -EINVAL;
 	}

drivers/crypto/atmel-sha.c

@@ -434,7 +434,7 @@ static int atmel_sha_init(struct ahash_request *req)
 
 	ctx->flags = 0;
 
-	dev_dbg(dd->dev, "init: digest size: %d\n",
+	dev_dbg(dd->dev, "init: digest size: %u\n",
 		crypto_ahash_digestsize(tfm));
 
 	switch (crypto_ahash_digestsize(tfm)) {
@@ -1102,7 +1102,7 @@ static int atmel_sha_start(struct atmel_sha_dev *dd)
 	struct atmel_sha_reqctx *ctx = ahash_request_ctx(req);
 	int err;
 
-	dev_dbg(dd->dev, "handling new req, op: %lu, nbytes: %d\n",
+	dev_dbg(dd->dev, "handling new req, op: %lu, nbytes: %u\n",
 						ctx->op, req->nbytes);
 
 	err = atmel_sha_hw_init(dd);