pinctrl: qcom: handle input-enable pinconf property

This enables support of 'input-enable' pinconf generic property in
the pinctrl driver.
Signed-off-by: Stanimir Varbanov <svarbanov@mm-sol.com>
Acked-by: Bjorn Andersson <bjorn.andersson@sonymobile.com>
Reviewed-by: Stephen Boyd <sboyd@codeaurora.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

drivers/pinctrl/qcom/pinctrl-msm.c

@@ -193,6 +193,7 @@ static int msm_config_reg(struct msm_pinctrl *pctrl,
 		*mask = 7;
 		break;
 	case PIN_CONFIG_OUTPUT:
+	case PIN_CONFIG_INPUT_ENABLE:
 		*bit = g->oe_bit;
 		*mask = 1;
 		break;
@@ -260,6 +261,12 @@ static int msm_config_group_get(struct pinctrl_dev *pctldev,
 		val = readl(pctrl->regs + g->io_reg);
 		arg = !!(val & BIT(g->in_bit));
 		break;
+	case PIN_CONFIG_INPUT_ENABLE:
+		/* Pin is output */
+		if (arg)
+			return -EINVAL;
+		arg = 1;
+		break;
 	default:
 		return -ENOTSUPP;
 	}
@@ -330,6 +337,10 @@ static int msm_config_group_set(struct pinctrl_dev *pctldev,
 			/* enable output */
 			arg = 1;
 			break;
+		case PIN_CONFIG_INPUT_ENABLE:
+			/* disable output */
+			arg = 0;
+			break;
 		default:
 			dev_err(pctrl->dev, "Unsupported config parameter: %x\n",
 				param);