x86: k8 numa register active regions later

Impact: cleanup

don't register early, so we don't need to clear actived regions if it fail
to get node hash shift or wild set in nb config.

also remove nodeids array that is not needed
Signed-off-by: Yinghai Lu <yinghai@kernel.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>

arch/x86/mm/k8topology_64.c

@@ -81,7 +81,6 @@ int __init k8_scan_nodes(unsigned long start, unsigned long end)
 	unsigned numnodes, cores, bits, apicid_base;
 	unsigned long prevbase;
 	struct bootnode nodes[8];
-	unsigned char nodeids[8];
 	int i, j, nb, found = 0;
 	u32 nodeid, reg;
 
@@ -110,7 +109,6 @@ int __init k8_scan_nodes(unsigned long start, unsigned long end)
 		limit = read_pci_config(0, nb, 1, 0x44 + i*8);
 
 		nodeid = limit & 7;
-		nodeids[i] = nodeid;
 		if ((base & 3) == 0) {
 			if (i < numnodes)
 				printk("Skipping disabled node %d\n", i);
@@ -179,9 +177,6 @@ int __init k8_scan_nodes(unsigned long start, unsigned long end)
 
 		nodes[nodeid].start = base;
 		nodes[nodeid].end = limit;
-		e820_register_active_regions(nodeid,
-				nodes[nodeid].start >> PAGE_SHIFT,
-				nodes[nodeid].end >> PAGE_SHIFT);
 
 		prevbase = base;
 
@@ -211,12 +206,15 @@ int __init k8_scan_nodes(unsigned long start, unsigned long end)
 	}
 
 	for (i = 0; i < 8; i++) {
-		if (nodes[i].start != nodes[i].end) {
-			nodeid = nodeids[i];
-			for (j = apicid_base; j < cores + apicid_base; j++)
-				apicid_to_node[(nodeid << bits) + j] = i;
-			setup_node_bootmem(i, nodes[i].start, nodes[i].end);
-		}
+		if (nodes[i].start == nodes[i].end)
+			continue;
+
+		e820_register_active_regions(i,
+				nodes[i].start >> PAGE_SHIFT,
+				nodes[i].end >> PAGE_SHIFT);
+		for (j = apicid_base; j < cores + apicid_base; j++)
+			apicid_to_node[(i << bits) + j] = i;
+		setup_node_bootmem(i, nodes[i].start, nodes[i].end);
 	}
 
 	numa_init_array();