mlxsw: spectrum_nve: Replace error code with EINVAL

Adding a VLAN on a port can trigger the offload of a VXLAN tunnel which
is already a member in the VLAN. In case the configuration of the VXLAN
is not supported, the driver would return -EOPNOTSUPP.

This is problematic since bridge code does not interpret this as error,
but rather that it should try to setup the VLAN using the 8021q driver
instead of switchdev.

Fixes: d70e42b2 ("mlxsw: spectrum: Enable VxLAN enslavement to VLAN-aware bridges")
Signed-off-by: Ido Schimmel <idosch@mellanox.com>
Reviewed-by: Petr Machata <petrm@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/mellanox/mlxsw/spectrum_nve.c

@@ -816,14 +816,14 @@ int mlxsw_sp_nve_fid_enable(struct mlxsw_sp *mlxsw_sp, struct mlxsw_sp_fid *fid,
 	ops = nve->nve_ops_arr[params->type];
 
 	if (!ops->can_offload(nve, params->dev, extack))
-		return -EOPNOTSUPP;
+		return -EINVAL;
 
 	memset(&config, 0, sizeof(config));
 	ops->nve_config(nve, params->dev, &config);
 	if (nve->num_nve_tunnels &&
 	    memcmp(&config, &nve->config, sizeof(config))) {
 		NL_SET_ERR_MSG_MOD(extack, "Conflicting NVE tunnels configuration");
-		return -EOPNOTSUPP;
+		return -EINVAL;
 	}
 
 	err = mlxsw_sp_nve_tunnel_init(mlxsw_sp, &config);