Commit 452e5eef authored by Wolfram Sang's avatar Wolfram Sang Committed by Ulf Hansson

mmc: tmio: Add UHS-I mode support

Based on work by Shinobu Uehara and Ben Dooks. This adds the voltage
switch operation needed for all UHS-I modes, but not the tuning needed
for SDR-104 which will come later.
Signed-off-by: default avatarBen Hutchings <ben.hutchings@codethink.co.uk>
Signed-off-by: default avatarWolfram Sang <wsa+renesas@sang-engineering.com>
Signed-off-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
parent 2fb55956
......@@ -101,6 +101,8 @@ struct tmio_mmc_host {
void (*clk_disable)(struct tmio_mmc_host *host);
int (*multi_io_quirk)(struct mmc_card *card,
unsigned int direction, int blk_size);
int (*start_signal_voltage_switch)(struct mmc_host *mmc,
struct mmc_ios *ios);
};
struct tmio_mmc_host *tmio_mmc_host_alloc(struct platform_device *pdev);
......
......@@ -1012,12 +1012,20 @@ static int tmio_multi_io_quirk(struct mmc_card *card,
return blk_size;
}
static const struct mmc_host_ops tmio_mmc_ops = {
static int tmio_mmc_card_busy(struct mmc_host *mmc)
{
struct tmio_mmc_host *host = mmc_priv(mmc);
return !(sd_ctrl_read32(host, CTL_STATUS2) & TMIO_STATUS2_DAT0);
}
static struct mmc_host_ops tmio_mmc_ops = {
.request = tmio_mmc_request,
.set_ios = tmio_mmc_set_ios,
.get_ro = tmio_mmc_get_ro,
.get_cd = mmc_gpio_get_cd,
.enable_sdio_irq = tmio_mmc_enable_sdio_irq,
.card_busy = tmio_mmc_card_busy,
.multi_io_quirk = tmio_multi_io_quirk,
};
......@@ -1116,7 +1124,9 @@ int tmio_mmc_host_probe(struct tmio_mmc_host *_host,
goto host_free;
}
tmio_mmc_ops.start_signal_voltage_switch = _host->start_signal_voltage_switch;
mmc->ops = &tmio_mmc_ops;
mmc->caps |= MMC_CAP_4_BIT_DATA | pdata->capabilities;
mmc->caps2 |= pdata->capabilities2;
mmc->max_segs = 32;
......
......@@ -63,6 +63,8 @@
#define TMIO_STAT_CMD_BUSY 0x40000000
#define TMIO_STAT_ILL_ACCESS 0x80000000
#define TMIO_STATUS2_DAT0 BIT(7)
#define CLK_CTL_DIV_MASK 0xff
#define CLK_CTL_SCLKEN BIT(8)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment