Commit 45c99533 authored by Eric W. Biederman's avatar Eric W. Biederman Committed by Linus Torvalds

[PATCH] Use delayed disable mode of ioapic edge triggered interrupts

Komuro reports that ISA interrupts do not work after a disable_irq(),
causing some PCMCIA drivers to not work, with messages like

	eth0: Asix AX88190: io 0x300, irq 3, hw_addr xx:xx:xx:xx:xx:xx
	eth0: found link beat
	eth0: autonegotiation complete: 100baseT-FD selected
	eth0: interrupt(s) dropped!
	eth0: interrupt(s) dropped!
	eth0: interrupt(s) dropped!
	...

Linus Torvalds <torvalds@osdl.org> said:

  "Now, edge-triggered interrupts are a _lot_ harder to mask, because the
   Intel APIC is an unbelievable piece of sh*t, and has the edge-detect logic
   _before_ the mask logic, so if a edge happens _while_ the device is
   masked, you'll never ever see the edge ever again (unmasking will not
   cause a new edge, so you simply lost the interrupt).

   So when you "mask" an edge-triggered IRQ, you can't really mask it at all,
   because if you did that, you'd lose it forever if the IRQ comes in while
   you masked it. Instead, we're supposed to leave it active, and set a flag,
   and IF the IRQ comes in, we just remember it, and mask it at that point
   instead, and then on unmasking, we have to replay it by sending a
   self-IPI."

This trivial patch solves the problem.
Signed-off-by: default avatarEric W. Biederman <ebiederm@xmission.com>
Cc: Ingo Molnar <mingo@redhat.com>
Acked-by: default avatarKomuro <komurojun-mbn@nifty.com>
Signed-off-by: default avatarLinus Torvalds <torvalds@osdl.org>
parent 134a11f0
......@@ -1287,9 +1287,11 @@ static void ioapic_register_intr(int irq, int vector, unsigned long trigger)
trigger == IOAPIC_LEVEL)
set_irq_chip_and_handler_name(irq, &ioapic_chip,
handle_fasteoi_irq, "fasteoi");
else
else {
irq_desc[irq].status |= IRQ_DELAYED_DISABLE;
set_irq_chip_and_handler_name(irq, &ioapic_chip,
handle_edge_irq, "edge");
}
set_intr_gate(vector, interrupt[irq]);
}
......
......@@ -790,9 +790,11 @@ static void ioapic_register_intr(int irq, int vector, unsigned long trigger)
trigger == IOAPIC_LEVEL)
set_irq_chip_and_handler_name(irq, &ioapic_chip,
handle_fasteoi_irq, "fasteoi");
else
else {
irq_desc[irq].status |= IRQ_DELAYED_DISABLE;
set_irq_chip_and_handler_name(irq, &ioapic_chip,
handle_edge_irq, "edge");
}
}
static void __init setup_IO_APIC_irqs(void)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment