Commit 472eaf8b authored by Abhijeet Dharmapurikar's avatar Abhijeet Dharmapurikar Committed by Greg Kroah-Hartman

spmi: pmic-arb: check apid enabled before calling the handler

The driver currently invokes the apid handler (periph_handler())
once it sees that the summary status bit for that apid is set.

However the hardware is designed to set that bit even if the apid
interrupts are disabled. The driver should check whether the apid
is indeed enabled before calling the apid handler.
Signed-off-by: default avatarAbhijeet Dharmapurikar <adharmap@codeaurora.org>
Signed-off-by: default avatarKiran Gunda <kgunda@codeaurora.org>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 5f9b2ea3
......@@ -536,8 +536,8 @@ static void pmic_arb_chained_irq(struct irq_desc *desc)
void __iomem *intr = pa->intr;
int first = pa->min_apid >> 5;
int last = pa->max_apid >> 5;
u32 status;
int i, id;
u32 status, enable;
int i, id, apid;
chained_irq_enter(chip, desc);
......@@ -547,7 +547,11 @@ static void pmic_arb_chained_irq(struct irq_desc *desc)
while (status) {
id = ffs(status) - 1;
status &= ~BIT(id);
periph_interrupt(pa, id + i * 32);
apid = id + i * 32;
enable = readl_relaxed(intr +
pa->ver_ops->acc_enable(apid));
if (enable & SPMI_PIC_ACC_ENABLE_BIT)
periph_interrupt(pa, apid);
}
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment