Commit 4934ab95 authored by Simon Wunderlich's avatar Simon Wunderlich Committed by Antonio Quartulli

batman-adv: don't allow ECTP traffic on batman-adv

We have seen this to break networks when used with bridge loop
avoidance. As we can't see any benefit from sending these ancient frames
via our mesh, we just drop them.
Signed-off-by: default avatarSimon Wunderlich <siwu@hrz.tu-chemnitz.de>
Signed-off-by: default avatarAntonio Quartulli <ordex@autistici.org>
parent fe3f4cfe
......@@ -146,8 +146,10 @@ static int batadv_interface_tx(struct sk_buff *skb,
struct batadv_bcast_packet *bcast_packet;
struct vlan_ethhdr *vhdr;
__be16 ethertype = __constant_htons(BATADV_ETH_P_BATMAN);
static const uint8_t stp_addr[ETH_ALEN] = {0x01, 0x80, 0xC2, 0x00, 0x00,
0x00};
static const uint8_t stp_addr[ETH_ALEN] = {0x01, 0x80, 0xC2, 0x00,
0x00, 0x00};
static const uint8_t ectp_addr[ETH_ALEN] = {0xCF, 0x00, 0x00, 0x00,
0x00, 0x00};
unsigned int header_len = 0;
int data_len = skb->len, ret;
short vid __maybe_unused = -1;
......@@ -180,10 +182,16 @@ static int batadv_interface_tx(struct sk_buff *skb,
/* don't accept stp packets. STP does not help in meshes.
* better use the bridge loop avoidance ...
*
* The same goes for ECTP sent at least by some Cisco Switches,
* it might confuse the mesh when used with bridge loop avoidance.
*/
if (batadv_compare_eth(ethhdr->h_dest, stp_addr))
goto dropped;
if (batadv_compare_eth(ethhdr->h_dest, ectp_addr))
goto dropped;
if (is_multicast_ether_addr(ethhdr->h_dest)) {
do_bcast = true;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment