Commit 4bd888a8 authored by Marc Kleine-Budde's avatar Marc Kleine-Budde

can: flexcan: activate individual RX masking and initialize reg_rximr

Modern flexcan IP cores support two RX modes. One is using the 6 fames deep
hardware FIFO, the other is using up to 64 mailboxes (in non FIFO mode). For
now only the HW FIFO mode is activated.

In order to make use of the RX mailboxes the individual RX masking feature has
to be activated, otherwise matching mailboxes are overwritten during the
reception process. This however switches on the individual RX masking, which
uses reg_rximr registers for masking.

This patch activates the individual RX masking feature unconditionally and
initializes the mask registers (reg_rximr) with 0x0 == "don't care", which
switches off any filtering.
Signed-off-by: default avatarMarc Kleine-Budde <mkl@pengutronix.de>
parent 30164759
......@@ -779,6 +779,7 @@ static int flexcan_chip_start(struct net_device *dev)
* only supervisor access
* enable warning int
* disable local echo
* enable individual RX masking
* choose format C
* set max mailbox number
*/
......@@ -786,7 +787,8 @@ static int flexcan_chip_start(struct net_device *dev)
reg_mcr &= ~FLEXCAN_MCR_MAXMB(0xff);
reg_mcr |= FLEXCAN_MCR_FRZ | FLEXCAN_MCR_FEN | FLEXCAN_MCR_HALT |
FLEXCAN_MCR_SUPV | FLEXCAN_MCR_WRN_EN | FLEXCAN_MCR_SRX_DIS |
FLEXCAN_MCR_IDAM_C | FLEXCAN_MCR_MAXMB(priv->tx_mb_idx);
FLEXCAN_MCR_IRMQ | FLEXCAN_MCR_IDAM_C |
FLEXCAN_MCR_MAXMB(priv->tx_mb_idx);
netdev_dbg(dev, "%s: writing mcr=0x%08x", __func__, reg_mcr);
flexcan_write(reg_mcr, &regs->mcr);
......@@ -845,6 +847,10 @@ static int flexcan_chip_start(struct net_device *dev)
if (priv->devtype_data->quirks & FLEXCAN_QUIRK_DISABLE_RXFG)
flexcan_write(0x0, &regs->rxfgmask);
/* clear acceptance filters */
for (i = 0; i < ARRAY_SIZE(regs->mb); i++)
flexcan_write(0, &regs->rximr[i]);
/* On Vybrid, disable memory error detection interrupts
* and freeze mode.
* This also works around errata e5295 which generates
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment