Commit 51c27da1 authored by Linus Walleij's avatar Linus Walleij

gpio: wm831x: use the new open drain callback

The WM831x GPIOs clearly have a dedicated open drain control
register. Implement support for controlling this from GPIO
descriptor tables or other hardware descriptions such as
device tree by implementing the .set_single_ended() callback.

Before this patch, lines requesting open drain will just be
switched to input mode by the framework, thus emulating open
drain. But the hardware can do the real thing, so let's
support that.

As part of this, rename the debugfs string for output mode
from "CMOS" to "push-pull" because it is the term used in
the framework to signify a tomem-pole CMOS output.

Cc: patches@opensource.wolfsonmicro.com
Cc: Mark Brown <broonie@kernel.org>
Acked-by: default avatarCharles Keepax <ckeepax@opensource.wolfsonmicro.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
parent 640b9135
......@@ -132,6 +132,28 @@ static int wm831x_gpio_set_debounce(struct gpio_chip *chip, unsigned offset,
return wm831x_set_bits(wm831x, reg, WM831X_GPN_FN_MASK, fn);
}
static int wm831x_set_single_ended(struct gpio_chip *chip,
unsigned int offset,
enum single_ended_mode mode)
{
struct wm831x_gpio *wm831x_gpio = gpiochip_get_data(chip);
struct wm831x *wm831x = wm831x_gpio->wm831x;
int reg = WM831X_GPIO1_CONTROL + offset;
switch (mode) {
case LINE_MODE_OPEN_DRAIN:
return wm831x_set_bits(wm831x, reg,
WM831X_GPN_OD_MASK, WM831X_GPN_OD);
case LINE_MODE_PUSH_PULL:
return wm831x_set_bits(wm831x, reg,
WM831X_GPN_OD_MASK, 0);
default:
break;
}
return -ENOTSUPP;
}
#ifdef CONFIG_DEBUG_FS
static void wm831x_gpio_dbg_show(struct seq_file *s, struct gpio_chip *chip)
{
......@@ -216,7 +238,7 @@ static void wm831x_gpio_dbg_show(struct seq_file *s, struct gpio_chip *chip)
pull,
powerdomain,
reg & WM831X_GPN_POL ? "" : " inverted",
reg & WM831X_GPN_OD ? "open-drain" : "CMOS",
reg & WM831X_GPN_OD ? "open-drain" : "push-pull",
tristated ? " tristated" : "",
reg);
}
......@@ -234,6 +256,7 @@ static struct gpio_chip template_chip = {
.set = wm831x_gpio_set,
.to_irq = wm831x_gpio_to_irq,
.set_debounce = wm831x_gpio_set_debounce,
.set_single_ended = wm831x_set_single_ended,
.dbg_show = wm831x_gpio_dbg_show,
.can_sleep = true,
};
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment